how to cut down a shotgun barrel part 1

measure and cut

Category:

Education

Tags:

• how
• to
• cut
• down
• shotgun
• barrel
• part

[Colonoscope]

No disrespect meant, and I almost never leave negatve feedback - But you did a poor job, in your own words, used poor tools, vulgar language, and left everyone with a poor example of how to cut a shotgun barrel down.

Next time just don't post if things don't go right. Not trying to be mean about it - just a word of advice.

[njrobinson95]

"Once you get in there decently deep"

That's what she said.

[TheTruck1973]

It is a lot easier if you use a pipe cutter. It takes about a third of the time and it's straight everytime.

[Soulrider2012]

That's funny...this kid blames the hacksaw for his inability to make a straight cut. Please tell us exactly how a hack saw is responsible for cutting the barrel at an angle that is a 1/4 of an inch off?? I'm sorry, I was wrong it's not funny, it's pathetic. Take responsibility and just admit you made a bad cut.

[droldsw31]

Put a metal blade on a miter box, MAYBE?

[ilovetohavelonglogin]

@Colonoscope who the fuck cares its home video. not everyone sets up a studio for youtube videos calm down.

[DIECASTER]

OR,...you could use the pipe cutter first for a few

turns around the barrel, then use the hacksaw to

cut all the way through...^_^

[camachoman123]

could you use a dremel to do this??

[TopRamenKing]

@Colonoscope Hey during bad times alot of us cant afford decent power tools and saws and cutting tools OR pay people to do it so yes this vid is some what educational , my personal opinion if your involved or engaged in something like a natural disaster or wrol "without rule of law" and you need to conceal your firearm if necessary then yes this is something you should watch IF your a complete idiot and cant figure out or figure how to shorten a barrel if needed.

[1967cbd]

If i were your dad i'd beat your ass and you never would even look a another hacksaw again ;p

[serpent08n]

you'd be better off having a gunsmith or at least a machinist cut it in a lathe

[kennyfsu]

Thanks.