Mock up carb adapter for victa

Just showing my mock up carb adapter for the victa commando 160cc 2 stroke mower engine. The adapter is so i can mount a little 2 stroke chainsaw carby to the engine.

Category:

Education

Tags:

• victa
• mower
• engine
• motor
• stroke
• 160cc
• 167cc
• 125cc
• carby
• carburettor
• adapter

[bigblockluv]

i hate 2 say that carb is 2small and that long of an adapter tube the fule will proly frezz if it dose run and ull loose power butt good luck i hope it dose work 4 u

[brendonv101]

The tube isnt going to be that long, it will only be like 1cm long lol.

[jay15kz]

that might not work if you look on the front of the carb throttle side there is a small hole that needs to be connected to the crank case it operates a small diaphragm that pumps the fuel from the tank

[brendonv101]

yer i no, how it works.

[geoff390]

to make the little diaphrame pump work.

[chaddauphin]

why do carb adapters need a pulse

[geoff390]

yea doesnt really matter anymore im sending him a carby.

[applegoneairsoft]

Or you can get small threaded hose hookups and do a case pulse tap.

[geoff390]

It connectes through the intake manifold. You could try to make a little hole inthe crankcase but you might just ruin the whole engine

[brendonv101]

I dont see how that hole works, How does it connect to the crank case? If i router out a little slit from the "pulse hole" to the centre hole will that work?

[geoff390]

Doesnt matter how long the adapter is it still needs the pulse hole.

[Cchange4us]

what about the crankcase pressure port your going to have to figure that out

[brendonv101]

its a 2 stroke engine not a 4 stroke.

[carltonkid25]

It should work because the adapter is a longer manifold, when you think about it.