Trailer Brake Controller Installation - 2005 Ford Freestar - etrailer.com

http://www.etrailer.com/Brake-Controller/Tekonsha/39510.html

Videos are provided as a guide only. Refer to manufacturer
installation instructions and specs for complete information.

Today on this 2005 Ford Freestar we are going to install part number 39510, the Voyager brake controller. We are also going to use the ETBC7 kit to install this. And we are going to need an extra bracket and that is going to be part number 18140. The first thing we need to do is go ahead and install the bracket for the 7-pole. And what is going to happen is we are going to install it on the bottom of the hitch, just like this. And then we will go ahead and clamp it in position. We are going to use the clamp that holds everything in place. Then we will take the bracket that comes with the ETBC7 kit and we will just go ahead and bolt it on. What we are going to do is actually just wind this up in electric tape and leave our leads out that we need. We will leave our 4-pole sticking out and we are going to need our brake wire which is going to be blue and our black wire for 12 volt power supply. And then we will just wrap up our purple and white wire. Our white wire is going to go directly to the frame for ground. And then the purple wire is going to be for reverse lights, if it is ever needed. And to our black and blue wire we are going to install a gray cable which has the black and white wires inside of it. What we are going to do is just peel away the gray sheath and stripe our wires back and make our connections. And we are going to go black to black and white to blue. Cover those up with some electric tape. Next we will go ahead and install the loom along the wires like this. 1:36

Category:

Autos & Vehicles

Tags:

• etrailer.com
• 39510
• ETBC7
• 18140
• 20127
• trailer
• brake
• break
• controller
• controllor
• control
• install
• installation
• tekonsha
• voyager
• 2005
• ford
• freestar
• freestar ford 2005