Trailer Wiring Harness Install Jeep Grand Cherokee - etrailer.com

http://www.etrailer.com/tv-wiring_install_2003_jeep_grand_cherokee.aspx

Videos are provided as a guide only. Refer to manufacturer
installation instructions and specs for complete information.

Today we are going to be installing a wiring harness 118369 which will fit 1999 to 2004 Jeep Grand Cherokee. We are inside the back hatch now of the Grand Cherokee. There are also going to be 3 screws we are going to have to remove to access the wiring harness. You need to remove this screw here on the threshold. Both of these screws are here for the cargo tie down. Both of which need to be removed also. With these 3 screws removed we want to go ahead and remove this whole interior panel here. Besides the screws there are push rivet fasteners that are all inside here and along the inside of the side pieces as well. So we need to gain access to the interiors so we need to pop this side off. Go ahead and remove the bottom cargo tray to give us a little more room to work.

We are going to take a long bladed screw driver or anything that can fit inside the side panel here to pop away the rivets. Once that one is done you can pretty much just pull away and listen to them click and pop out of there. With the interior panel pulled back here you can see the piece of rubber threshold here. You will want to go ahead and pull that on back. That will gain us access to the wiring harness which is right there with the green connector. We will take our T harness and they pop right in together. From there we want to go ahead and as you can see on the back of the modulite box here is some double sided tape. We want to go ahead and clean off the surface on the inside here. Next you can go ahead and remove the covering and tape it like so. They do provide a zip tie in the kit. What we have to do is route the 4 pole wiring along side the factory harness here.

We will just zip tie that to it. With the harness attached and the 4 pole ran, we will put the plastic grommet back up and through here and into position. The 4 pole will actually stay inside the vehicle we will just run it down inside the trim here. We can put the paneling back on now. As you can see we went ahead and ran the 4 pole down and below here. This 4 pole is just going to stay inside and you can just pull it out of the rear of the vehicle when necessary. With that done the only thing left to do is to reinstall the screws we took out earlier. This completes the install of part number 118369 on our 2003 Jeep Grand Cherokee.
Videos are provided as a guide only. Refer to manufacturer
installation instructions and specs for complete information.

Category:

Autos & Vehicles

Tags:

• trailer
• wiring
• harness
• install
• installation
• 2003
• jeep
• grand
• cherokee
• etrailer
• etrailer.com