Holden Commodore VR V6 With T70 Turbo. Startup, idle and small revs

Just testing out the new HD camera, figured I might as well do a new video showing what the car is like now. Still very much a work in progress, shown by mismatched leads and cable ties.

But for those who are interested, the simple specs are:

Factory Unopened L27 Buick V6 Engine
(decent) Chinese T70 0.70 front 0.84 rear (Running 10psi atm)
DSR 38mm Wastegate with 7.4psi spring
Tial "styled" 50mm Blow off valve
Bosch EV1 44lb Injectors
GM 2 bar MAP sensor
Re-tuned delco ecu for all mods
Full 3" intercooler piping with a 600x300x76 FMIC
Full custom made 3" Exhaust with 2 450mm Coby's
Using factory drivers manifold with custom crossover pipe merges into custom passengers manifold then into the turbo
Shift kitted / Corvette servo fitted 4l60E transmission with large trans cooler

Car has done upwards of 2500km since this most recent setup and has been handling it quite well, only problems so far have been the air filter, and leads melting but apart from that, it's been a real pleasure. Next on the list is some form of locked diff, and a few more psi in the intake!

Category:

Autos & Vehicles

Tags:

• turbo
• commodore
• vn
• vp
• vr
• vs
• buick
• v6

[stu69a]

how the turbo holding up 

[chrchr11]

@stu69a its getting no use at the moment due to a few upgrades here and there, but should be going again soon :)

[TheCYPRUSBOY]

how much did it cost total .

[chrchr11]

@TheCYPRUSBOY I could make the same setup again for around 3 grand (nz)

[skidpiggy]

the other option is a vortech side mount charger ;)

[chrchr11]

@skidpiggy I had a sc14 on their before, they're just as bad as any side mount charger. Power is not usable and at the same psi feels pretty slow compared to the turbo. I think i'll stick with the ability to get good 1/4 times as opposed to high dyno print outs.

[mastalinksta]

Nice job , looks good. :)

[JRKilby89]

Do a burn out

[Tindogga]

yeah the one i have is auto

[chrchr11]

@Tindogga Nothing, stock as. With the proper setup and tune, they handle even 14psi without any issues. Only thing is having to shiftkit the transmission if its auto. Otherwise they dont last! good thing is that its only $200 or so for a transgo kit.