GEETs on F350 01-16-2011 vblog3.wmv

I'm working on a slightly larger GEET for the truck than the 2 that are on the truck right now.

Category:

Science & Technology

Tags:

• GEET
• fuel
• reformer
• plasma
• reforming
• steam
• Paul
• Pantone

[maxhydro]

So when you have a generator with vertical exhaust, would you go about either centering the rod or modify the exhaustpipe and mount an horizontal piece so the rod can go it's own way?

[narivasant]

@maxhydro

Vertical orientations are the easiest for the rod to center on its own. Horizontal orientations are a little harder but it still should occur naturally with a good flow through it like a generator should have. If you join our research group you can see a photo of the rod floating in the middle of a horizontal GEET, taken through a sight glass window at the end. see the yahoo group VortexHeatExchanger. Then look in photos: "Cahoons Genny and Experiments"

[maxhydro]

the kids didn't disturb at all, it's all a matter of focus....

what i've learnd to center the rod is to weld 3 blobs around each end of the rod, in equal 120 degrees of the 360, hand grind them down if u don't have a laith so that the rod is more or less ffixed in de middle of the pipe, once it wore down the pipe wall to make a hole after 15.000km' but that was a 1,3 mm stainless pipe. for the lenght ways moving i cross drilled 2 holes in a 90 degree angle tru the pipe at the points where

Max

[narivasant]

@maxhydro

I started out years ago also making 3 centering posts at front and back until many of us in the research group found we got better results with no centering posts. That works with strong suction available. With low suction, still have to use centering posts. I don't try to center too much length wise because Paul Pantone says that a better reaction comes when the rod naturally gets electromagnetically pulled lengthwise to the position where is has the strongest reaction.

[pxmstr]

will you shut the kids up!

[narivasant]

@pxmstr

Yes, I'll keep them quiet next time.

I guess I get used to it and tune it out. ;^)

[maxhydro]

the kids didn't disturb at all, it's all a matter of focus....

Max