TransVerter / Part 1

Reproduction of TransVerter anomalous reactive power amplification as previously done by Dan Combine, Raivo, Jinis and of course Hector D. Perez Torres.

The power metering of power IN uses specific hardware of the Philips PE1540 power supply. The internal PE1540 shunt resistance is 166mohms = 1/6 ohms so at 30VDC, non-ferroresonance requires 1.5mV hence 1.5*6 = 8.4mA so average Pin = 8.4mA * 30VDC = 0.25W. Once ferroresonance manifest anomalous VAR amplification (VAR = reactive power), PSU provides 2.3mV instead 1.4mV so 2.3/1.4 = 65% increase of power IN to get the ultra-nonlinear parametric effect but generates 4 times more VAR power still at same 30VDC powersupply (average doubling of reactive current and average doubling of reactive voltage circulating through LC tank as shown on tek2445 oscilloscope).

P.S.1. Oscilloscope shows secondary reactive voltage with 50V/div and secondary reactive current with 50mA/div. The comparison 30VDC working point shows peak to peak sinusoidals 35V-AC and 40mA-AC equals to 35*0.04/2 hence 0.7 VAR when non-ferroresonant effect. Once ferro-effect manifests, VAR is self-amplified by a factor much higher than excess input energy eventhough we keep 30VDC from power-supply.

Each MWO Panasonic inverter flyback have around 130mH inductance, 4.5ohms internal resistance. The resonant capacitor is 220nF so we have 890Hz subharmonic heterodyne resonance. The single leg H-bridge runs with 50% duty cycle unipolar PWM at 890Hz as opposed to Dan Combine double leg full H-bridge demo on YouTube with 33% duty cycle bipolar PWM at 142Hz.

P.S.2. Please see schematics of Philips powersupply PE1540 used in this experiment at page 15 of http://www.virtual-train.org/Matthias/documentatie/pe1540.pdf

Next video will show specific toplogy to extract part of the anomalous excess VAR without detuning the ferro ZPE effect coupling with vacuum in order to estimate power OUT.

P.S.3. With Transverter, it is the brutal collapse of highly magnetic saturation which couples from vacuum whereas with plasma reactor, it is the brutal collapse of highly electrostatic saturation with couples excess energy from vacuum.

Category:

Science & Technology

Tags:

• TransVerter
• Scalar
• Waves
• Hector
• Perez
• Torres
• Dan
• Combine
• Raivo
• Jinis
• Parametric
• oscillator
• Mixer
• Ferro-Resonance
• ZPE
• Anomalous
• energy
• amplification
• OverUnity
• Panasonic
• MWO
• inverter
• flyback

[selfonlypath]

@Texmurphy51: you might read the book "Principles of ultra-relativity" written by Pr Seiki Shinichi supported by official Japanese research labs.

[Texmurphy51]

@selfonlypath "sometimes start freezing"

Show me a link to these experiments & who conducted them.

Your claims would change science if they can be proven.

I dont doubt someone has made these claims but they have to be replicated in a lab.

[selfonlypath]

@Texmurphy51: well I can tell you that some ZPE reactor once pumping energy from vacuum do have their temperature going down, sometimes start freezing so are you really sure about the Maxwell's demon impossibility ?

Other effects of ZPE operating reactor in its near-field:

- time modification

- mass decreasing

Sometimes, you can get the 3 effects together ;)

P.S. About Casimir effects, you need to encompass the dynamical Casimir effects, not the static ones as you've described.

[Texmurphy51]

@selfonlypath "yes, a ZPE reactor is an implementation of a "Maxwell's demon" device"

Then why not tap heat energy instead?

It is much much more dense then Quantum flux.

I dont think you understand why Maxwells demon is not possible do you?

Please explain how this is ZPE reactor is suppose to work.

How is it suppose to tap energy from virtual particals,in space.

The casimer effect calculates the energy density to be very small

You need plates the size of the earth to get any usable power.

[selfonlypath]

yes, a ZPE reactor is an implementation of a "Maxwell's demon" device.

Another interesting ressource is Ilya Prigogine 1977 Nobel prize withd 3 rules for designing such system to self-organizes itself:

- needs to be highly nonlinear

- suddenly put far away from its equilibrium

- has an energy flow

Quantum flux aka energy flow

[Texmurphy51]

@nadinka007 Under quantum theory there is quantum flux, IE random energy in the vacuum.

However the same applies to our atmosphere. There is heat energy in all the air you breath.

To capture it you would need Maxwells Demon,(look it up if you dont understand).

You are doing the same trying to capture the quantum flux energy.

[nadinka007]

@Texmurphy51

Quick question smart ass: what is nowhere? What is emtyness of vacuum?

[Texmurphy51]

@selfonlypath Well where do you believe the energy is coming from?

How are you getting extra energy from nowhere?

[selfonlypath]

@Texmurphy51: The Transverter ZPE reactor has nothing to do with BEMF.

[Texmurphy51]

If I get the idea correctly this is the same as what Steorn claims. That is he wants to recover so called "Back EMF"

Problem is if you recover Back EMF then your power supply has to provide more energy since Back EMF blocks incoming current.

The more you extract from the circuit, the more the power supply will have to make up.

If this really worked then the power you extract should be able to replace the xternal power supply & it would run completely own its own.

[Jasonschmidtschannel]

nice work

[ashtweth]

Wonderful explanation and work my friend, flawless you did the "impossible", you translated Hector into English :) hehee . On a serious note, added to the RV page my friend to help did you post this already at EVGRAY and RV replications?