Dirt Bike Exhaust Installation

This BikeBandit.com How To Video overviews Dirt Bike Exhaust Installation with Steve Matthes and was produced by Transworld Motocross.

Stock dirt bikes come pretty plugged up these days. One of the best ways to get more performance out of both 2 stroke and 4 stroke dirt bikes is to install a new exhaust. There are a ton of options to choose from depending on your budget and performance mindset. A number of varieties of dirt bike exhaust can be found on the BikeBandit.com website at http://www.bikebandit.com/motorcycle-exhaust/g/a643652

When a more free flowing exhaust is installed on a dirt bike, it needs to be compensated with additional fuel and air for a uniform circuit. A uniform circuit allows for the dirt bike to operate at its peak performance. A jet kit will deliver more fuel to the dirt bike and a high flowing air filter will deliver more air. If the dirt bike is fuel injected, you'll need to install a fuel injection module instead of a jet kit. Jet kits for dirt bikes can be found on our website at http://www.bikebandit.com/jet-kits/cm/a676379, fuel injection modules can be found at http://www.bikebandit.com/fuel-injection/cm/a676375 and high flow aftermarket air filters can be found at http://www.bikebandit.com/air-filters/cm/a642495

Category:

Autos & Vehicles

Tags:

• Dirt
• Bike
• Exhaust
• Installation

[lungbo]

@NOREMAC770 use heat and lube it up! Run the bike for a while after you lube the bolt. The exhaust heat alone should be enough. Let it cool and try again. Worst case you have to use an oxy tourch to get the bolt out as when heated the bolt will expand and then cool down hopefully breaking any rust sealed in place. I had to do this with some seized linkage bearings.

[dough98boy]

hey im checking out a fmf minicore for my ttr 125 its a 03 and I would like to know what a spark areester does like do i need it?

[druminsk8]

@atvrider43 there are not jets theres no carb

[NOREMAC770]

@PartsBandit the bolt you took off at 0:28 is so tight on mine and i cannot get it off does that tool make it easier

[NZXTInerTia]

Yosh pipes <3

[atvrider43]

So on the Fuel injected bikes you dont have to jet the bike, Correct?????

[OLLY605]

Litterally didn't show any of the install!

[mxgoon19]

if you get a after market slip on do you have to rejet the carb or no

[BeatAssDude]

how do i know if my ktm 85 xc needs a top end i dont know but it sounds deeper or not as loud and is hard it start

[NaturalSniper17]

@WHATTHECOOK1 if yes then please do a tutorial