How to Replace a Indesit Washing Machine Door Lock, Interlock

http://www.aPart4u.co.uk Step by step instructions on fitting a new Indesit door interlock
This video is on how to change your door lock on a Indesit makes and models.
1st you need to remove the Indesit door retaining wire which can be held together in 3 different ways one is a spring clip two is a nylon hasp clip and third is a screw type, like an oversize jubilee clip
2nd you need to peel back the Indesit door seal or gasket to get access to the rear of the door lock before undoing the interlock
3rd you now need to undo the screws that hold the Indesit interlock in place then with your hand make sure it does not drop down inside the Indesit washing machine. Some door interlocks fit flush to the panel and others hook into the panel
4th we now need to unplug the wiring from the door Indesit interlock in some cases the wires are held in with a plug and in others they are held on by individual spade terminals. Remember were the wires come from its a good idea to draw a diagram, and if possible take a photo.
5th in most case they will be the same as the original but sometimes the new door lock may vary from the old one you took off. Please check for any additional information within the packaging as sometimes the manufacturers will have made modification changes which might mean there will be terminal changes or wiring alterations.
6th you will need to connect the Indesit washing machine wiring to the new door lock In most cases this will just mean connecting a plug that will only fit one way but if you have individual terminals you will have to consult your wiring
7th refit screws to your door Indesit interlock then fit seal or gasket to your front panel and replace the wire band.

Category:

Howto & Style

Tags:

• DOOR LOCK
• INTERLOCK
• DOOR SWITCH
• INDESIT INTERLOCK
• INDESIT DOOR LOCK
• INDESIT WASHING MACHINE