3/15/09 Lick Of The Week - Pedal board - MXR, George L's,Keeley,Xotic,Morley,Maxon, Cornford,Ibanez

This new LOTW is about my new Pedel Board set up, I am using the Pedal Train pro and running my Ibanez S series 24 fret guitar using George L's cables into a Ernie ball volume pedal then into my Digitech Whammy 1 - Morley Tremonti Wah - MXR phase 90 - Xotic BB pre - Ibanez modded by Keeley TS-9 - Keeley Compressor - Arion Chorus/vibe into a ISP Ddecimator and using on the baord a planet waves tuner as well as attached to my guitar I am using the one and only Intellitouch Tuner then going into my Cornford mk 50 11 head. Through the effects loop I am running the Maxon ad999 Pro delay.

I messed with a few sounds using the effects and the amp.
Enjoy!
RB

Category:

Music

Tags:

• Cornford
• mk5011
• Keeley
• Xotic
• Maxon
• Ibanez
• George
• L's
• IntellitouchMorley
• ISP
• Digitech
• Rob
• Balducci
• Favored
• Nations
• Steve
• Vai

[wallmethod]

Hey man tnx! I already have the cable... LOL I thought it was ten meters haha :) that when I got in the store I found out its 10 feet which is very short and only good for making patch cables... so I bought 2 ten feet george L's with nickel tip... BTW May I ask if you're encountering "loss" of low to mid frequencies with the the george L's nickel tip? bec when I strum I cannpt hear it coming back and forth, its like the treble dominates all the frequencies and it sounds like unidirectional :(

[RobBalducci]

@wallmethod hey ya.. I have never accounted any signal lost or frequency lost. to me they acutally increase everything you are syaing you are not hearing. Mkae sure the oonections are tight and try it again!!

Thx

[wallmethod]

hey man surely george L's gives the best signal... but the 10 feet is too long.. btw I'm planning to make a cable from george L's effects kit... do you think I will have a different king of tone by using george L's effects kit plugs? I mean from the main guitar cord to the patch cables. tnx

[RobBalducci]

hey ya... yes the tone will be awesome. No the effect cable kit is the same cable that they use for guitar cords so you will be fine!

[RobBalducci]

hey ya dougmaia yes you are right, it is a ernie ball volume ... and the guitar is a custom shop S series 24 fret. I was just waking up and this was the second time filming because the first take was to long.. so my head was a little messed up lol... thanks for pointing out the mess up. and for leaving the comments.

I did put the right information in the writing lol...

Rock

RB

[openmind1984]

Hey Rob just a quick question for you ... I was thinkin´about buyin that pedalboard with the hard case, just like yours....but it´s not this think too heavy ?¿? What do u think ?

[openmind1984]

Hey Rob just a quick question for you ... I was thinkin´about buyin that pedalboard with the hard case, just like yours....but it´s not this think too heavy ?¿? What do u think ?

[cavlovc1]

Rob-GREAT JOB!

[MrDarinWarren]

Woah, I just stumbled across your youtube page. We played with you at Jemfest a few years ago. I used to play with Shane Regal.

Good stuff man.

[Den1sVengeance]

What's up Rob! Since you stated that you have one of the new tk999's in your pedalboard aren't you going to demo it or even better.Make an update video of your pedalboard.Rock on!