Daniel Holman Extreme Flight 60 Edge 540T EXP
Loading...
1,611
Loading...
Uploader Comments (DanielPHolman)
see all
All Comments (16)
-
Hi Daniel!
Great flying!
What servo you use?
What plane better: extra 300 60" EXP or Edge 540T 60" EXP?
Thanks!
-
Nice Video!!! I have a question: do you use the Thro trim to keep the plane in low idle? some people says that the torque motor takes few seconds to speed up when pushing full thro. Thank you.
-
Thanks for the reply. The only reason why I was wondering if it twisted out under high g loops is because my 58 inch extra does it really bad.
-
The Extra will be extremely stable in all maneuvers and you won't have any problems like you described. I personally like the Extra even better than the Edge, but it's just personal preference as they're both amazing!
Loading...
Glad you enjoyed it! :-) I'm using JR DS3421 servos all around and they're great!
The Edge is best for 3D and the Extra is best for precision, but they're both excellent for all types of flying. The Extra is my favorite, but they're both amazing.
DanielPHolman 1 week ago
Glad you enjoyed the video. I personally don't use a throttle-up trim because I never bring the throttle all the way back. With that being said, I do agree that it's a good thing to do and I would recommend it.
DanielPHolman 4 months ago
@DanielPHolman , Thank you so much for taking the time to answer us. I have a last question: I will order the batteries for my plane, T nano tech 6s 3300 mah but there is different C rates and I am not sure what to order. I have the recommend set up fro EF (Airboss SC and Torque Motor). Where I will order the batteries they have 25-50c, 35-70c, 135c, Can you tell me what to get??
Thank you so much again for your time.
felipesgirl35 3 months ago
@felipesgirl35 Glad to help. Any C rating of 25+ will be fine. 135C is way overkill and I would go with this 35-70. The lowest C rating that you mentioned will be plenty though.
DanielPHolman 3 months ago
@DanielPHolman, Thank you!!
.....and I have other questions, I'm sorry. Do you solder the leads betweent the motor and ESC or you just conect the bullets?, Also, did you make a hole under the planes fuse to let air to go out?? The manual doesn't say about it but I have seen people doing it. Thank you Again and I'm sorry for all this questions.
Felipe.
felipesgirl35 3 months ago
@felipesgirl35 I just connected the bullet connectors. Yes, you will need to cut the hole in the bottom of the fuse for an air outlet.
DanielPHolman 3 months ago