TERRCO INC: DYEING A TERRCO LOGO

www.terrco.com - In this short video clip we are going to show the steps to dye a logo into any concrete surface. The process starts out the same as polishing a floor. The first couple steps are the rough grind and then move on to polishing. Once the 200 grit resin pads have been used it's time for the logo. First apply the template, then lay plastic to protect any area you don't want dye to touch, spray the dye (Terrco's concrete dyes are acetone based so they dry quickly) and finally peel up the remaining template pieces. Spray your densifier and continue polishing as you normally would.

Category:

Science & Technology

Tags:

• concrete
• dye
• logo
• polish
• terrco
• floor
• grinders
• polisher
• terrazzo
• dyed
• surface
• preparation