Honda BROS Hawk GT Exhaust Custom NT400 Construction

This is how to make a custom 2 into one exhaust, out of three exhaust tail pipes from the auto (car) store using an Inverter arc welder 2.5mm rods and 80 amps.
All these pipes are readily available from the auto store and used to adapt car exhausts. They come in short lengths.
Mine came from Cliffords in School lane Hove Sussex UK.
You start by getting two auto pipes which fit the Bros headers and you bend them with heat (cherry red) around 10 degrees.
I made a jig to keep them the right distance apart,
Both tube centres will close up by 3mm when removed from the jig after welding so make the jig 3mm wider.
You ten slash cut them with a 1mm cutting disk using a 4 1/2 " grinder. Cut them back at the end they meet to give the same size hole as the second bit you weld on. Find another socketed pipe which fits the slip silencer you want to fit and weld that on, just tack it on to start.
Buy a stainless silencer from ebay and cut it down half the length and re pack it.
Pop rivit the end cap back on, job done.
To read more on how to arc weld for beginners go to my site
http://www.jeeptent.co.uk

Category:

Autos & Vehicles

Tags:

• Honda
• Bros
• hawk
• gt
• nt400
• exhaust
• sound
• check
• headers
• custom
• two
• into
• one
• customise
• stubby
• can
• bros
• Hawk
• GT
• NT
• 400
• side
• exit

[ROCKsquareANORACK]

hello from chicago

[stuartstrong]

You certainly get around... weather has been wet and windy but got some camping in.

[petrolhead1977]

This is weirdly similar to my DIY Exhaust video. Well done.

[SRT480]

that a stick weld?

[EwanMands]

wt is the song man a want to make a dubstep remake????

[MrGreatCornolio]

What song use in this video??? Answer me please!))) Что за песня звучит в этом видео???)))

[vr6piloot]

nice, could you make me one too?!?!

[garyhgaryh]

What type of welder did you use? Nice job.

[beserka04]

that alright , good job mate , i work at a fabrication company and make all my own exhausts too , got some videos on youtube

[seanlucky7]

shit man..will ya make me one o those1..nice job.