what i did w/Re: Weekend Project: Make an Electronic Cricket
Loading...
4,224
Loading...
Uploader Comments (infamousartgallery1)
Video Responses
This video is a response to Weekend Project: Make an Electronic Cricket
see all
All Comments (13)
-
@infamousartgallery1 you should take apart a controller and use a weighted vibration motor, then hot glue it to the bottom of the tube.
-
where did you get the schematics? because i really like to build the electronic cricket. thanks
-
COOL !
just on that solar panel ??
-
A bit of a hack job on the cell phone. I suggest using scrap electronics for the rest instead of paying way to much at radio shack ... You could also use green LEDs to replace the solar cell ... you can find "info" on "greenwatts"
-
i have that same book. it is a must have book. that symet engine is so bombin. it works on like everything.
-
thanks
Loading...
if im using more motors do i need more capacitors im using 2200 uf 25v capacitors i have three if i do need to use more im going to run two motors
KleinSchnitzel 3 years ago
I don't think more caps will work even if they are the same motor. If one motor has a lower triggering point then all the power might just go to one motor and not both. I think each motor should have its own driving circuit. What are you making?
infamousartgallery1 3 years ago
what book do you have???
baziu6 3 years ago
The book is called "junkbots, Bugbots & bots on wheels" by Dave Hrynkiw and Mark W. Tilden
infamousartgallery1 3 years ago