30-30 Dent at 300 Yards

Trying to get that 2 inch sphere again with the Winchester. I must have just nicked the wire holding it then hit the same place that the 30-06 hit last time. The 30-30 doesn't dent that steel at 300 yards but it sure does look as if that dent is bigger. Maybe since the bullet was forced off center, the dynamics of the hit were more forceful?

I was about 1/2 inch high; I adjusted... Now that I think of it, I should have adjusted it one click instead of 2. I think the adjustments are a little larger than 1/4 inch at 100 yards; but the stickiness of the adjustments make it hard to figure. I'll find out next time.

Category:

Sports

Tags:

• shooting
• Winchester
• 30-30
• lever action
• gun
• rifle
• weapon
• BSA
• Deerhunter
• scope
• Hornady
• SST
• 300 yards

[thevansmack]

I hope that you're not putting those God damned SST bullets into your magazine....your scope and rings are also shit....that is all

[lj2justgoto]

@thevansmack Where do you see it being suggested that these are being used in the magazine?

...and you do understand that they will not cycle into the chamber if they were being loaded via the magazine, right?

...and your opinion on the scope mounts are cute, but I've made shots using them that you could only dream of accomplishing.

...and don't come to peoples video's being rude, were you raised in a barn?

[thevansmack]

@lj2justgoto lol....shots that I could only dream of....I just chuckled a little bit

[lj2justgoto]

@thevansmack It is simply learning proper load develop.

[lj2justgoto]

@DJonX7 LOL! The internet wouldn't be the same without them. ;)

[DJonX7]

@lj2justgoto Haha. dealing with dumbies.

[thevansmack]

@WhatUGawkinAt You should care....sst bullets are not to be used in tubular magazines and the only thing worse than owning a BSA scope is owning a BSA scope in see through rings.

[WhatUGawkinAt]

@thevansmack Noone cares about your pointless opinion.

[bluestudio67]

@mthunter95 Leverevoltion works fine in my M-30-30. No probs with fouling, etc

[TheFoundersWereRight]

@mthunter95 actually, i have heard of this practice using "Sharp" bullets like that in the 30-30. The practice involves the loading of only two rounds, then levering one into the chamber. This leaves a single round safely in the tube with no primer resting on the tip.