Replace a garage door opener
Loading...
Loading...
1:28
Installing a Garage Door Opener: Assembling the Rail and Motorby RONAinc29,039 views- 0:52
Craftsman Garage Door Opener Install-Proby searsbluetoolcrew20,057 views
- 4:01
Fixing the garage door openerby superdelsol14,842 views
- 4:38
iPhone controlled garage door opener using Arduinoby geoffmerck63,360 views
- 1:48
What's the Best Garage Door Opener?by jmurr11121,731 views
- 7:22
How to install a Garage Door From start to finish.by GarageDoorsMesa208,613 views
- 2:48
2703 Installing a Garage Door Openerby quin04754,252 views
- 2:51
Reset Garage Door Keypad Code PIN & Remote Control Openerby VerifyHistory123,831 views
- 0:11
Garage door opener not workingby inspectpros4,043 views
- 3:44
Class How NOT to install a garage door openerby GordonGFox34,256 views
- 36 videosChamberlain
- 2:20
How to Program Chamberlain Garage Door Opener Remoteby ChamberlainDIY15,084 views
- 4:56
Chamberlain Garage Door Opener Gear Replacementby prodoorparts10,315 views
- 2:03
Burnsville Minnesota Garage Door Repair 612-623-3667 Burnsville MN Garage Door Serviceby garagedoors00710,652 views
- 6:17
Garage Door Operation, Maintenance, Repair Video from GarageDoorCare.comby EdwardHowardGFX51,657 views
- 1:02
Craftsman Garage Door Opener Belt Driveby searsbluetoolcrew8,673 views
- 4:16
how to change a gear kit on a liftmaster sears craftsman or chamberlain opener part 1by 9ways2skin1cat11,322 views
- 3:27
Chamberlain 1/2 HP garage door openerby chicagolandhobby31,669 views
- 2:38
Mission: Install Sears Garage Door Opener Before Wife Comes Home!by pickleparade31,058 views
- 2:04
Brief demonstration of garage door break in and solutions.by ElocksysDOTcom59,804 views
- 1:17
3-IN-ONE Garage Door Lube - OFFICIAL Demonstrationby wd40company14,378 views
When you install the garage door opener, you are supposed to install the arm no lower than the top rollers. But, put it too high and the arm (black bar) will smack into the strut.
chicagolandhobby 2 years ago
I have a stupid question. How did you know how far down to attach that hanging part on to the door? Only watched this once. I think you had it screwed into the third hole from the top. Why did you put it there instead of the 1st, 2nd, or 4th?
tracy10UT 2 years ago
If I could make a suggestion, go to a hardware store and buy some punched steel angle and replace the old brackets at the powerhead with the punched steel angle. The stuff that comes with the opener isn't really good. I can even see this on the horizontal crossing bracket(it is bent) and the puched steel angle is much stronger.
chicagolandhobby 2 years ago
Ill tell u why it quiet working is because it was a genie!
sms373 2 years ago