Thorens TD-166 mkII problem.MOV
Loading...
Loading...
3:37
Thorens td 166 assembled with old woods-L'Hymne à l'amour-instrumentalby asguitarstereo5,008 views- 2:47
FRANK SINATRA - Blue moon - Thorens td 166 - Stanton 680 II.by asguitarstereo14,859 views
- 0:52
Thorens TD 166 Mk II by pinkmddby SIMONE88dd14,846 views
- 6:46
Thorens TD-166 mk II: David Naughton - Makin' Itby Audioquest562,709 views
- 0:41
Thorens TD160 Suspensionby shpater34,412 views
- 4:02
Thorensby skaglia249 views
- 7:14
DEEP PURPLE- Made in europe- Burn- Purple 1976- Thorens td 166- stanton 680 IIby asguitarstereo26,834 views
- 3:56
Mission 753, Rotel RA-980BX, Pro-ject RPM 1.3, Benz Micro MC Gold, Lehmann Black Cubeby Vouwfiets92,699 views
- 1:40
THORENS TD 160+ortofon VMS 30 HI END PHONO FINE 70'+marantz 2238 receiverby marchinocecco9,597 views
- 0:16
Thorens TD-160 + SME 3009by dmartin157,739 views
- 1:19
Technics SL-Q33 record player with Sure M97xEby sambam0075,502 views
- 2:30
Thorens TD 184by croutize2,327 views
- 1:18
My Thorens TD160by kabilaspur599 views
- 1:35
thorens phantasieby monet350020,106 views
- 2:16
Thorens TD 150 MK2 with tonearms in wood (1965)by PadronEdo6,861 views
- 0:36
DUAL CS 5000 AUDIOPHILE CONCEPT TURNTABLEby du6fztech6,684 views
- 2:48
How to change a belt on a belt driven turntable.by nn8nn6,473 views
- 4:43
Thorens TD124by n7ksi24,524 views
- 4:31
Rare Vinyl Pearl Jam 2001 Christmas Single feat. Ben Harperby mingusthecat19767,998 views
I had this problem too, and fixed it by replacing the belt (the original belt became a bit slack a guess). Also the wheel looks dirty, one might try to clean it with a bit of alcohol before replacing the belt .
DutchAlps 2 months ago
It is my gues you have adjusted the suspension. This may leave the turntable at an angle to the motor spindle giving rise to a problem you now have. My advise is to turn the large part of the turntable over and start the deck going. you can then determine which of the three suspension points need adjustment. I think the motor was fitted so the spindle was exactly erect so altering it may cause you to put the entire deck out meaning you never hear its at its full potential. Best of Luck
rodthesodful 4 months ago
The motor is secured to the plinth with three threaded studs. One of them is adjustable. Slightly loosen the fixed two and adjust the other one up or down as needed to make the belt travel all the way down to the bottom of the pulley without going off the plastic pulley. Your belt is not traveling down far enough. You need to angle the motor pulley shaft away from the main shaft. Needs to be adjusted after a new belt is installed usually. Nice table.
haras440 1 year ago