WE Scar trigger issue

As the video shows, the trigger works when selecting single, but not during auto. The hammer is locked in backward position, but not released again. What could the problem be?

Category:

Sports

Tags:

• WE
• Scar
• airsoft
• GBB
• problem
• problemshoot
• trigger
• hammer
• selector

[oneronin68]

I have the same problem, did you ever get this fixed ? if so what did you do?

[GZK1022]

is this co2 or green gas?

[Rossmancer]

@WETTImaintainence

I have the same problem. What do you mean "gun-smithed"? So is this actually a problem, or can it be fixed?

If you charge the gun in semi, and then switch to auto the gun works fine.

[WETTImaintainence]

One more thing. If you have problems while firing the gun, it may be due to improper installation of what I am assuming to be a TSC hammer on your gun. These custom hammers may need to be gun-smithed for proper installation.

[WETTImaintainence]

Here's the thing. You know that long bar piece looking thing? And that weird piece it is connected to at the end of the trigger assembly? When you click the hammer all the way back, it will get stuck by this piece (the sear). When you push the long bar forward, it releases the hammer so you can fire again. This is automatically done by the bolt.

[almostevil100]

when a gun is selected into full auto it will not fire like on semi, in other words put it into full auto push hammer back but this time when u go to pull the trigger there is going to be a black bar like peace on the right,u will see a little gray rectangle peace in the front holding it down and right in front of that a little black tab sticking up, u need to hold that forward when pulling trigger.

[SSJSasuke777]

I Think it Does the Same THing on mine but I wanna Ask did you put in a New Hammer Grouping or did the guys you ordered it from install it. because if you were able to get into the hammer grouping like take out the lower internals could you make a video of how to take it out