SHARK 006 3CH Alloy Mini Scale Indoor Flying by Syma

For new pilots ages 14 and up , Syma and Gemini brings you the S006 Shark Alloy, resistant to crash, light weight and with retractable blades to avoid damage to people or furniture.
Please do not let the Under 5 play with toys with small parts.

Get it today at:
http://stores.ebay.com/Dragon-Power-C...


Specifications:
Length: 375 mm
Width: 72 mm
Height: 190 mm
Main Rotor: 340 mm
Tail Rotor: 70 mm
Motor: 130kv
Battery: Li-po 3.7Volts

TAGS: Shark Alloy 3CH Syma 006 06 6 S006 Gemini DGC Beginner Pilot Helicopter Scale Mini 3D

Category:

Science & Technology

Tags:

• Shark
• Alloy
• 3CH
• Syma
• 006
• 06
• S006
• Gemini
• DGC
• Beginner
• Pilot
• Helicopter
• Scale
• Mini
• 3D

[BigSeanP]

My tip, and Ive had these for a while is to hold each stick between each thumb and forefinger rather than balancing your thumbs over the stick and moving that way. Far easier to react with more precision. These are superb helicopter, great outside but must have NO wind at all.

[AERORCTV]

Well it is an indoor model. :)

[evangelosadam]

where is the potentiometer again?

my chopper can not hover at all. It spins clock-wise and crashes

Any help?

[AERORCTV]

helicopters fly by Gyro systems. The Gyro you have could be faulty or the cables connected to it, I think is inside Gyro, look into the parts you have besides the speed controller another little box hooked to the servos, then that pieces could be, and is not assurance deffective, check your trims and calibrate them carefully, but also check the ends of the servos and connections between helicopter and servo.

[mYfLASK]

There is no Trim pot inside the transmitter, or under the S006 Canopy, Just spins out of control anti- clockwise, how do you get this to just hover.

[AERORCTV]

Spins out of control ?

How come ?

Only if you push the control to the edge that should not be happening.

[hoihaihey]

u can see the red LED light up on your charger :)

[mdani76]

Guys I bought this hely 1 day ago. You have to practice a little bit this toy; remember that everytime you change lift (up and down) you have to counteract the tendency to spin; you can trim only in hovering, but when she moves you need rapid fingers.

BUT when you start managing the machine, she flies very well and stable (also too much...); I noticed also that the battery recharger in the package is a little bit poor. Much better to have a serious lipo charger! and practice with a lot of space!

[t0v3]

how do i know if it is fully charged or not?