2000 Ford Lightning, Fully Built, 700+ RWHP- Walk around

2000 Ford Lightning, Fully Built, 700+ RWHP- Walk around

Details:
2000 Ford Lightning
Black/Gray
35,000 miles

Location: Southern NJ 08091

Fully built, front to back. Dead on reliable....
Legitimate 9 second truck.

Best run of 9.74 at 138mph
(This was done with a 100 shot of nitrous, kit has since been pulled off and sold. Was going to spin the 2.3 more or go with a bigger blower to hit mid 9's again this spring)

Truck has run best of 10.5's on just blower, would run a 10.2 to 10.3 I believe with same driver from nitrous run (Evan Smith of MM&FF's only pass was the 9.74 run versus owners low 10 second runs using exact same setup)

Want a 9 second truck??
Up the boost, upgrade blower, or add a cheap 100 shot and there you are.......


Dyno:
650rwhp on pump
680rwhp on race gas
780rwhp on race gas with 100 wet shot (again, gone)

STREET TRUCK!!!!
Driven anytime, anywhere, still has all power acc, A/C, heat, etc.....

Modifications:
7-10K miles on all major modifications

Engine:
New 2004 Block
Steel Crank (1000 HP)
ARP Main Studs
ARP Head Studs
Manley Rods (900 HP)
JDM Spec'd Pistons
JDM Spec'd Bearing and Rings
High Volume Oil Pump
Ford Head Castings, CNC Ported to JDM Specs (stage 2)
Stainless Steel Shim Head Gaskets
16 New Stainless Steel Valves
16 New Valve Guide Seals
16 New Lifters
16 New Cam Followers
Titanium Retainers
Factory Keepers
Stage 2 Cams
New Rear Main Seal
2 New Timing Chain Gears
2 New OEM Timing Chains
4 New Guides
2 New OEM Oil Tensioners
2 New Case-Hardened Guide Pins
New Freeze Plugs
Blueprinted and Balanced
Ported Lower Intake Manifold
Oil Pan
Oil Pump Pickup
Timing Chain Cover and Seals
Valve Covers
SCT 90mm MAF

Power adder:
Whipple 2.3 twin screw (3.75" pulley, comes with 3" also)


Transmission:
BTS Built 4R100
PI 2400 stall
Valve body
Everything inside is new and upgraded, clutches, drives, input/output shafts, etc

Rear:
Rebuilt 9.75 with 3.73 gears

Fuel system:
Intank Billet fuel pump assembly
Dual Walbro 255lph pumps
Braided line from pumps
Mallory hi flow fuel filter
JDM Fuel rails with boost sensitive pressure regulator
60lb injectors

Exhaust:
Kooks LT headers
Magnaflow mids with Hi flow cats
Magnaflow catback

Suspension:
JDM front drag springs
JLP 4" shackles in rear
QA1 adjustables at all corners
58" JDM long bars
Driveshaft loop
Modified stock brakes to fit 15" rims

Miscellaneous:
JDM Heat exchanger
JDM electric fan kit
Cervinis 3" cowl hood
Lund rollpan
6 point bar with removable door bars
Lexan rear window with working sliding glass middle
Tonneau cover (cut around rollbar)
Stock stereo/tape player with 6 CD changer
Autometer boost gauge
Aeroforce Interceptor gauge
Modified stock seats (buckets now instead of 60/40)
Expedition center console
Console lid custom covered to match stock seats
RCI Racing harness for drivers side
Rear, suspension, brakes all coated with POR-15 paint

Wheels/tires:
Currently the truck sits on
Front: 16x7 F150 rims painted black with chrome trim ring, Hankook 245/75/16
Rear: 15x10 JDM custom made rims with Hoosier 295/65/15 Drag Radials


For right price/trade, I also will have available:
-Wet Okole custom seat covers in black/silver
-Centerline Qualifier rims in 17x7 and 17x11 custom made in correct bolt pattern with correct BS etc
with Falken Ziex 235/60/17 fronts and M&H 390/40/17 rear Drag Radials
All new and still on order.....about 2 weeks out from being shipped to me.


This truck was completely built, front to back by JDM Engineering in Central NJ,
there was (with labor/fabrication work) over 70K spent to bring this truck up to what it is.
There is easily over $40K in parts....

Category:

Autos & Vehicles

Tags:

• Picture

[ChinkEyesDaily420]

those rims are weak

[southjerseystang]

@ChinkEyesDaily420

And what do you have that makes them "weak", you stoner idiot??

[FastClones]

chrome tail lights are for hondas



[southjerseystang]

@FastClones

Another rider of the short bus emerges.....

[FastClones]

@southjerseystang i have never ridden on a short bus, and chrome tails like look like shit on every vehicle

[southjerseystang]

@FastClones

You might want to start. They are stock tails off of 01+ Lightnings.

[Xxjordan23fanxX]

yea know that i think of it its a pretty bad ass truck nd srry for hating bro

[ChrisSparxxx]

@Xxjordan23fanxX Come on bro, the wheels and tires are his drag set up and those "Tubes" you are talking about is his roll cage!!!!

[JettaArts]

i think the rims are sexy looks mean as fuck nice build.

[Xxjordan23fanxX]

I love lightnings but man u made ures look like shit u need2 change ure rims , tires , and take those gay ass tubes on the back ....man y is it that the fuckin mexicans have the better looking trucks nd I give them props for that

[S73PHEN]

nice man



[5nip3r6]

wtf is up with these comments, fucken haters man those are the stock lights, and for a performance truck u aint gonna trow no fucken shity 26 or 28s those are the best rims for slicks(sticky tire made for drag racing) for those idiots that think they are the shit talking smack over the internet. . sick truck man wish u swung by az i would love to race against u man.

[HMTRACING313]

dont worry bout all these fckn idiots hating on ur truck man!....its sick! im looking to buy one!

[ThePaxel]

Im not a Ford Fan.....but thats a fine looking ride you got.......

[pedropistolas18]

HEY I HAVE A 2000 LIGHTNING AND I BLEW THE HEAD COIL ON THE PASEN SIDE,,, CAN I JUST GET RE CHANGE THEM WITH REG 5.4 HEADS!!!