blaster for trade or sale

The quad has Vito's racing big bore kit (250cc), 34mm Kahein Racing Carb, fmf big fatty pipe, dg muffler, msr dominator handlebars, new front brake pads and lines, new throttle line, magnetic oil plug, new front sprocket, oil injection block off kit, new itp holeshot XCR tires in the back, +5 wheel spacers, hydraulic back brake, new axle, all new bearings front and back. The engine has low hours because I didn't ride a lot after I rebuilded it, I use 100 octane fuel and 1:32 ratio so the motor is clean.

Category:

Autos & Vehicles

Tags:

• blaster

[Bartong666]

its already sold but ill still keep the vid up, they are fun little bikes but require a lot of maintenance

[justme21x]

ill trade you my truck!!!!

[Bartong666]

what truck if your intrested then send me a pic

[YFZRIDR91]

how good do those rear tires hook up? do they wear easy?

[Bartong666]

they a pretty good, this is my 2nd sezon on them but if you ride a lil bit on concrete or asphalt then you can tell that the wear down really quick

[alarconedu]

why you selling?

[Bartong666]

too small for me, and i need more power

[Phantom2942]

wuz u lookn to trade

[Phantom2942]

i had one that wuz bored 40 over that shit jumped in first an second thrird if ya good enough

[Phantom2942]

is it 250 two stroke

[MrSweetleaf92]

@fastblaster240 gotchya

[fastblaster240]

@MrSweetleaf92 im saying if u have a stock bore and then u get a stroker ull get about 3cc pre mil if u get a 240 big bore kit and a stroker ull get more cc sence ur bore wieder

[MrSweetleaf92]

@fastblaster240 if you add a stroker your not adding anything to the bore. you adding three millimeters to your stroke so that would be 3mills extra on your up stroke and 3mills extra on your down stroke. you have the right idea but wrong dementions. still either way you have the CC convertion right so it does add up and i see what your getting at

[fastblaster240]

@MrSweetleaf92 ok look at it 3mil=9cc 3x3=9 so about every mill =3cc so itd be ;ike 12cc! and if its a 240bore ull gain more because ur bores wierder and ur making ur stroke longer so id say ud prolly get about 4-5cc pre mil

[MrSweetleaf92]

@58atvrider you do NOT wanna use wheel spacers if you wanna stretch it that far. if you wanna stretch it 4 inches you should consider a longer axle and A-arms

[MrSweetleaf92]

@fastblaster240 if you wanna get technical the blaster isnt even a 200, its a 195 so if you were to add a 3mil stroker then it would be a 205 and if a 3mill adds 9CCs then how the hell do you figure a 4mil adds 10? that makes no since at all......

[fastblaster240]

@MrSweetleaf92 noa +3 is like +9cc so ud have a 209 witch would not jack shit for power