Buba fuel cell complette
Uploader Comments (RonL2524)
All Comments (26)
-
Anyway... good production of gas.
-
YEAH it is COMPLETTE :DDD LOL;
-
It's ok I think I've found a solution apparently theres a porous glass membrane that uses silver and palladium to filter out the oxygen. The gas is too unstable with oxygen still in it to be used as a substitute for natural gas that is to say that with the oxygen in the pipes if it were to ignite and you had a store for the gas it could explode. But without the oxygen the ignition would not be able to travel through the pipes and would not explode. Thanks for your reply.
-
Hi Raybinns-sorry i took so long to reply.
i don't know an easy way to separate the gases.-as far as i know-hho is great mix (ratio of oxygen & hydrogen)for combustion so i have been focusing on using the gas output as is.
sorry i couldn't help more, but thanks for the question.
-
Wow everybody's got an opinion on the easy stuff where the fuck are you all when I ask a question that requires an answer which involves using those little grey cells? jeez I know they've flouridated the water to dumb ppl down but I had no idea things had gotten this Bad.
-
Anybody?
-
Do you know if there is a way of separating the gas? I know you can build one with the cathodes and anodes on opposite ends and partition the system but that method is less efficient as I have concluded from tests that 6mm separation with alternating cathodes and anodes will give optimum performance. ideally I would like to extract and vent the oxygen to leave pure hydrogen.
-
I'm sorry man but I got alot more gas just w/ a piece of 3" pvc pipe w/ 2 bolts and a few washers and nuts
is the tube going from the bubbler to the main tank above or below water in the main tank??
yungthugluvlife 3 years ago
Thanks for question yungthugluvlife-at the time-bubbler was lower than tank but i hear it's better to have bubbler level or above cell-tube should be above cell water level-thanks for the interest
RonL2524 3 years ago
i also have couple of questions...
1. how would i put this in my car so i can get better gas mileage?
2. are the bubbles in the bubbler hydrogen bubbles?
gissome1234 3 years ago
Thanks for the question gissome1234.-#1-build a safer cell with a bubbler & connect output to your intake & venturi vacuum on your car engine(either use 2 cells-(prefered method)1 for venturi vacuum & anouther for intake vacuum or use check vavles for single cell install-you might have to modify your car to run leaner)-we are still testing & haven't gotten milage data yet.
RonL2524 3 years ago