honda civic mini me 11:1c zc/d16z6 port polish head

first test but more to come!

Category:

Autos & Vehicles

Tags:

• VID
• 00004
• 20100814
• 1919

[pcihector]

so ZC pistons installed on a D16Z6 engine should not hit valves?

[joemoneyluxurious]

the block is sohc zc so I have pm6 and not p29 piston so I dont know about your question but I know you need a goooooood tune to run p29 cause the high compression you will have and dont milled your head , mine is .40 milled , I got it like that from the guy who sold me the motor

[3675omlc]

nice vid lets see a shot of the motor... im about to mini me my zc to

[joemoneyluxurious]

sorry no pic but its really normal, but its work really good for me!

[nctomaneng]

What chipped ecu are you running ?

[bikesandme123]

i have this same set up. itsw a good set up

[EvokDubstep]

@pcihector dont use the ex metal head gasket.

[EvokDubstep]

@joemoneyluxurious not really. you need to run 91 octane and have a apexi vafc. i had a jdm d15b with p29's. no problems at all. i was also running a y8 head and not a z6. yes, the head of the piston comes out the block of a d15b, clearance is compensated by using the d16 composite head gasket and not the mls head gasket