Monitor blinking power button repair
Uploader Comments (ToppervisionEnt)
All Comments (16)
-
Ha - I was looking for tips on my current monitor, but as it happens I have that exact monitor sitting in my basement (and it died in much the same way). I don't know how to do circuit repairs exactly, but those were good tips (re: capacitors). Thank you!
-
Use a higher Voltage value for the one that vented. Doing so should stop the problem from happening again so that any voltage spike wont vent it again.
-
@shadowhand56 Capacitors are you for two major uses, one is as a filter to clean the signal or remove interference the other is to time, manipulate the signal. Eg if you wanted the monitor to turn on each back light with a second delay you can use a resistor and a capacitor connected to a transistor base which means the transistor wont conduct until the capacitor reaches X charge.
-
@shadowhand56 i think the reason why they use capacitors is coz they can hold and release power quickly thats why i think maybe lol
-
Thanks for the video - Found my bad capacitor and fixed my monitor :) saved a bunch my first time
-
It is good video that can identify the faulty capacitors. Thanks
-
very good tutorial.
What is the software that you are using to capture and edit this video?
thanks
-
where do u buy those capacitors ?
-
I have a Dell 15" FPC monitor that the power button keeps blinking on and off I checked the power board caps and they look ok any suggestions?
ive been looking at some random circuit boards lately, and I wonder why is it that what they all have in common is that they have a lot of capacitors on them? I understand why they have a lot of IC chips, but i always see a bunch of capacitors. Is it necessary?
shadowhand56 1 year ago
@shadowhand56 It must be, they're still on everything. I don't know a whole lot about engineering the board.
ToppervisionEnt 1 year ago
Mike - a man of many talents. I used to be a camcorder repairman and I have replaced very many electrolytic caps in the past - especially the small silver ones. For circuits that run hot and/or being used in hot environments - go for the 105 degree type. It is satisfying to fix things isn't it? Good tutorial.
alanstarkie2001 1 year ago
@alanstarkie2001 Indeed. I like salvaging things that seem doomed. Curiously, as you mention camcorders, I'm gonna try to fix the Sony. And I'll film it with the Xacti.
ToppervisionEnt 1 year ago