Anti-Tipping Device, Exclusive Design by "WINK"

Loading...

Sign in or sign up now!
Alert icon
Upgrade to the latest Flash Player for improved playback performance. Upgrade now or more info.
52,582
Loading...
Alert icon
Sign in or sign up now!
Alert icon

Uploaded by on Oct 29, 2010

Today , through extensive research and development, Jimmy Wink has developed the next generation of half round and square dump trailers. This new concept is unique because it combines two proven materials, aluminum and plastic.This new composite design has taken an additional 1,000 pounds out of the lightest half round and/or square dump trailer currently being built and sold by allowing the plastic to take the place of aluminum sheet and redesigning the aluminum extrusions to provide all the necessary strength. This concept is going to revolutionize this industry, having the same impact as aluminum did when it replaced the traditional steel trailers. This composite design has several advantages in addition to the lighter empty weight. This unique design will help reduce the cost of operation such as insurance cost (because it will cost less to repair), replacement cost to replace the wear part (liner), fuel efficiency and durability. The current all aluminum trailer design cost $16,000 - $25,000 to repair in a tip over accident. This new composite design will allow section repair of the aluminum skeleton without the need to replace the expensive sheets that make up the sides, which are very labor intense. This new composite design will greatly reduce the cost of tip over by up to 50 percent. It will no longer need any side sheet replacement because the plastic will flex in a tip over and will most likely not need repairing. However, this plastic can be repaired through a welding process just like aluminum or steel. The current all aluminum design cost about $6,000 to have just the floor section repaired when it gets worn out. To replace the entire liner skin in the new composite design will cost approximately $8,000 to have a totally new bed.

  • likes, 5 dislikes

Link to this comment:

Share to:
see all

All Comments (3)

Sign In or Sign Up now to post a comment!
  • I was going to post on a different video about the need for someone to design something just like this ! Great idea , just like specialks 1953 below said.

  • Good idea; do you plan on licensing this to other manufacturers or offering it as a retro fit?

  • Very good idea, I hope it catches on. It shuld save some lives, injuries and equipment.

Loading...
Alert icon
0 / 00Unsaved Playlist Return to active list
    1. Your queue is empty. Add videos to your queue using this button:
      or sign in to load a different list.
    Loading...Loading...Saving...
    • Clear all videos from this list
    • Learn more