HHO inductor for a buck converter

How to make an inductor for your HHO
in this circuit ....
buck converter...........it uses a very big inductor, the diode you see is just if the neg overloads with pos voltage......then the diode lets the pos go to the pos wire.
this is a pos and neg inductor.....the speed that the pulses tune to.......there is no colapse, just constant amp draw. the inductor evens out the pulse. the pulse controls the amp flow. both coils are primary and the direction of pos and neg pulses are a natural flow of a magnetic field.
this circuit is designed to control an amperage pulse.....to any amperage you wish.
this is not meyers circuit. the diode is in the wrong place and voltage will drop with this circuit.
but amperage is controled.....i chose 20 amps as a control, because it is easy to use from the car.
so at 12 volts and 20 amps input.............output at the cell will be 3 volts and 80 amps.....roughly.
hope this explains things
http://www.docstoc.com/profile/irondmax

Category:

Science & Technology

Tags:

• stan
• meyers
• inductor
• buck
• converter
• HHO
• hydrogen

[ney299]

that kind of geraor is to generate more gas than dry cell?

[irondmax]

@ney299 the big inductor holds amperage and releases it slowly, converts volts to amps

[ney299]

friend live in Brazil, I wonder what was the materials you used

[irondmax]

@ney299 the welding rods are low carbon welding rods, which are soft iron and do not become magnetised. if you need the exact type, i will look for it

the wire is common electrical wire for a house, 12 ga

[irondmax]

@zcsaba77 leave the rubber on the wire, its part of the inductor

[zcsaba77]

@irondmax need peel out insulation from wire or just let on it, before turn onto rod?

[irondmax]

@dreamsean you already wapped it.............try it out take your 2 wires and wrap 10 coils each, side by side...just wrap around the outside

[dreamsean]

A pleasant day Mr. Robbinhood, i just mere wrapped aroun the 12 gauge house wire 90 turns only end to end tip trough standard size welding rod..... does it possibly work even only 90 turns????100 thanks

[irondmax]

@dreamsean just have to give it a try..........if theres smoke......try it again