1993 Geo Metro engine vibration
Loading...
Uploader Comments (rmcelwee)
All Comments (18)
-
My '94 shakes like that but runs smoothly through acceleration, and at speed it's fine too. I removed the left front motor mount and found it very deteriorated. Apparently the mount is not available so I did the urethane repair trick and it worked well for about two years...almost eliminating all vibration. I'd bet that mount is causing your vibration problems too.
-
@rmcelwee Thank you RM for that very quick reply back on my question. I took a look at your LS miata, and she's a beauty. She must be a real neck snapper, I know you'll have a lot of fun with that car. Anyhow thank you again sir, your help is greatly appreciated. Friends Q ^___^
-
at least it looks clean i think my timing is off but cant aford a timing gun right know to check it.
3:38
How To: Setting the Timingby kymetro999910,053 views- 1:13
95 Geo/Toyota 4AFE rattleby frogmommy12,055 views
- 0:52
Bad Engine Mountby gnetic8628,922 views
- 0:05
Torque converter and flexplateby bazlegro12,021 views
- 7:12
1992 Geo Metro LSi Convertible- Do Not Buy One With an Engine That Sounds Like This!by CincinnatiGifts6,771 views
- 2:30
geo metro tuningby 612170294141,026 views
- 2:27
Geo Metro Engine Pull Time Lapseby PeoriaGangsta1,788 views
- 1:07
Dampen Car Vibrations and road noise by ENORMIS of Erie, PAby enormis185,154 views
- 1:02
1994 GEO METRO 3 CILINDER SUZUKI MOTOR RUNNINGby veggiepowered7,776 views
- 1:11
Chevrolet (Geo) Metro cold start after 5 months winter storageby matd012,130 views
- 0:52
94 geo metro dyno run 1by kiknlif1,728 views
- 2:14
Turbo Geo Metro dragstrip (Seriously)by tchdwnuga85,718 views
- 0:52
Diesel Geo Metrol....IT LIVES!by kimmer636,511 views
- 0:23
93 geo metro w/ MK1 3 cylinder turbo motor, big ass cam & 2" pipe with glass packby sean104202,230 views
- 1:27
car at stop has engine problemsby thisredtaurus2,065 views
- 0:39
1991 Geo metro Xfi- warm engine idlingby zukhauler7,288 views
- 4:18
Changing your timing belt early can save you thousands!by willchase150,226 views
- 1:10
Camry Engine Vibration (Outside)by trdcamry084,286 views
- 0:34
1993 geo metro commercialby reich9676,061 views
Hey rmcelwee, I just changed timing belt on my 96 1.0L. The car has lots of power and runs fine. But I too have engine vibration, I'm going to get a timing light to see where the engines is at. I know it should be around 8 degrees before TDC. Was is the timing off one tooth that caused your engine vibration ? Please help another metronian out, go Geo Metro Forum !!!! Thank you !!!!!
qs711 8 months ago
@qs711
I checked the teeth and they were ok (not a tooth off). I've sold the car so I can't check anything else out on it.
rmcelwee 8 months ago
all the geo metro motors shook
veggiepowered 11 months ago
@veggiepowered
None of my other 3 Metros shook and the motor didn't shake before I rebuilt it.
rmcelwee 11 months ago
@rmcelwee you said you checked the mounts. and they looked good. did you check to see hte mounting bolts were tightened to spec? could be a misfire. not sure on that. other than vibes how did it drive?
yamahonkawazuki 7 months ago
@yamahonkawazuki The mounting bolts were fine. The car felt sluggish but that could have been from the extreme gear ratios that I was running (replaced the 4.39 vert tranny with one from an XFI) to get the car up to 50 MPG.
rmcelwee 7 months ago