Silhouette 3D from Great Planes
Loading...
623
views
Loading...
Uploader Comments (innervoid375m)
see all
All Comments (10)
-
@CYCO274 its a 11x4.7 slow flier prop i believe. i also use a wooden master airscrew 10X6 but not as good for 3d but still good.
-
@mrfourtysevenman what prop would be good for that set up?
-
Nice flying. Great flat spins.
Doodboy1
-
@innervoid375m omg i do too.
Loading...
use a turnigy 1050Kv motor with hobbyking 15-18A esc TRUST ME and corona metal gear servos. better than GP's setup.
mrfourtysevenman 11 months ago
@mrfourtysevenman Thanks for the comment. Are you referring to the Turnigy 28-30 1050kV motor ? I have one in my RichModels Firedragon, it is a powerhouse. Where do you get the Corona servos from ?
innervoid375m 11 months ago
@innervoid375m yes. and this is the servo.
/hobbyking/store/uh_viewItem()asp?idProduct=14459
mrfourtysevenman 11 months ago
@mrfourtysevenman I've never noticed these servos on their website before. Will try them.
innervoid375m 11 months ago
@innervoid375m okay but DO NOT put 6 volts into these. they are already very fast and responsive for anolog servos. do you have any tips on how to strengthen the elevator? the side of the elevator that is not connected to the servo flexes. im thinking of making it have 2 elevator servos.
mrfourtysevenman 11 months ago
@mrfourtysevenman I've noticed it too, and used fibre reinforced tape on the top and bottom of the involved elevator half, along the oblique edge closest to the rudder, up to the hinge line. It improved but is still present.
innervoid375m 11 months ago