How to Airsoft: Installing an AB MOSFET

Advantages of and AB MOSFET:
1. Increased Rate of Fire (1-4 rps)
2. Better trigger response
3. Saves trigger contacts when using Lipos
4. Stops the motor the split second you let go of the trigger

I did do a close up scene of licking my fingers but that looked to pornoish if you know what I mean...

Email:
theairsoftreviewer1@yahoo.com

Category:

Entertainment

Tags:

• How
• to
• Airsoft:
• Installing
• an
• AB
• MOSFET
• theairsoftreviewer1

[SHWELL11]

Have you looked into the 2 gate wire setups yet. I find them much easier to install. But, you are doing a great job. Keep up the progression man.

[TheAirsoftReviewer1]

@SHWELL11 I have but those get a little too complicated for me and I like just using the three wires so it doesn't take up that much more room.

[Raneuvfire]

did u make ur own mosfets? if so, could u tell me what u used to make em?

[TheAirsoftReviewer1]

@Raneuvfire I do but why would I give away my secrets ;)

[thedrummiester]

hey i have an echo 1 m4 that i got cause all my guns were borken. i want to make it lipo ready. what would you recomend doing

[TheAirsoftReviewer1]

@thedrummiester Get a mosfet, re-shim, new piston.

[GravitysGame]

Why use a motorkiller mosfet? only difference is less noise.

[Mountain117]

try bending the 33k resistor so it overlaps the mosfet, and bend the 100ohm resistor so it goes from the back of the mosfet (so that the gate wire comes up from the metal square) 30dollars for poor built mosfet is quite lot of money, not hating, just trying to give u some advice for the built quality, less wobbling parts in it u know :) ps sorry for bad english

[ovandolah14]

Hey i know pretty much everything about a gearbox except for the wiring stuff which i didn't really want to learn. However im kinda sick of paying labor to have someone else do it i want to do it myself but im not sure what to use for the sawdering part.

[andromedarr]

@SHWELL11 I have a 1 gate MOSFET, and it is very easy to turn it into something like a 2 gate MOSFET:

Just solder a small gate wire to the motor tab of the red wire, and then connect that to the switch. It has all the advantages of real 2 gate mosfets.

[JahDropper]

Could you show a video on how to do this with a gun that uses a Micro switch?

[AznXmodder]

If I buy one could you connect a tamiya connector for me? And do you include heat shrink?

[Lihaschu]

what's that m14 you were using?



[1337xmod]

hey hey hey how about a shooting video? or maybe like a comparison with and without. my local store charges $100 for the mosfet and labor but it would be cheaper if I can get the parts for cheaper. if you know what i mean

[Nelsonh396]

Omg i want to buy it But i dont have the money. Ill buy it once I get my barrett Guarenteened expect me near christmas or black friday

[AirsoftDomonation]

haw can you tell there active braking?