331 11:1 COMP AFM N-71 CAM

No description available.

Category:

Autos & Vehicles

Tags:

• 331
• N-71

[shortfusejay]

I seen you have some vids of this car with this setup at the track........what kind of times did you average?

[86regal454]

@shortfusejay , it's run a best of 10.84 @127 on motor , and 10.44 @ 130 on a 100shot a little more tuning and it should run 9.99 on 150 shot

[331lilcoupe]

what gears are u using? 4.10 ,4.30

[331lilcoupe]

do u know how much hp ur pushing!!!

[fidstang]

@86regal454

junkyard 302 HO 150 bucks

Victor Jr knock off heads 800 bucks

Victor Jr knock off intake 140 bucks

Holley 670cfm 350 bucks

240/248 and .576" lift 105 ICL 300bucks

4.88 gears 150 bucks

Rings, bearing, balance rotating assembly, hone block

total 2410 bucks.

Shift at 7000rpm, through the traps at 7200-7400rpm. Even bad drivers will get into the low 11's with this setup.

[jaycm74]

@86regal454 ....That's impressive , sounds like you had your combo all but perfect. How was the driveability of that cam on the street?

[oneshotkill324]

@86regal454 You can get a junkyard 400m for like 300 bucks fully dressed. Snagg a decent set of heads for around 1200, get a decent carb for 300, and a nice custom cam for like 250. It'll still make boat loads of torque and a decent amount of horsepower.

[86regal454]

@oneshotkill324 would never happen

[oneshotkill324]

@86regal454 a 400m. A decent 351w. Bolt some AFR 225's and a nice custom ground cam with a decent carb and either of those will put down some serious numbers, and of course more torque than a 6.0. Honestly it's not that difficult. I think you just did that so you could say that you have a GM motor in a Ford car. Well dude there are plenty of 302 based cars that'll hand you your ass in the 1/4. Just sayin. Ford > GM

[86regal454]

@oneshotkill324 show me a ford motor i can pull out of the junkyard , bolt a set of heads and cam in and run in the 10's N/A allday for under $ 2500.00