Bedini Pulse Motor with reed switch and relay 02

This is my second video of my pulse motor.
It is simply being pulsed by a single coil at 12V using a reed switch and relay to time the pulses - 4 pulses per revolution.
I am using very small neo (rare earth) magnets that are stuck around the cd flywheel.
I have added a small light to see the pulses and a diode to protect the transformer that delivers 12V from receiving the back EMF. I have already fried a transformer because of this.
What is the best way to catch the back emf? Obviously some sort of rectifier... Any advice would be much appreciated!

Category:

Science & Technology

Tags:

• Bedini
• Pulse
• Motor
• Free
• Energy
• Overunity
• Nikola
• Tesla
• LindemmanTom
• Bearden
• Joseph
• Newman
• DIY
• Electronics
• Homemade
• Reed

[sirmikeydotcom]

I think that overunity is producing more energy than consumed, and it does not really matter how you get there. This has to be verified by measuring volt/amp/watt input and output. Some folks are satisfied with merely reducing energy consumed, and this is where most of these projects sit.

[dodoshlodo]

these machines seem to tap something Tesla described as radiant energy. Often digital multimetres show false reading when dealing with Radiant energy. My multimeter blew up the other day when I tried to measure the Back EMF coming of the coil.

The idea of Free Energy is stupid, u cant energy for free. But u can tap this source of radiant energy that we know little about. Energy is not being created, just used from the vaccuum.

[dodoshlodo]

We see electricity as electron flow in a single direction, our multimeters can only measure this. however radiant energy behaves in a very unconventional way.

I have built a Radiant Oscillator that uses the same principles as the Bedini circuit, it can light a CFL globe with only the positive side connected (as well as charge a secondary battery)! the circuit isnt closed! so clearly we are dealing with somethin very different. It can even be conducted through plastic and through the air.

[dodoshlodo]

chek this out:

watch?v=6m6QCqNd6gE&feature=ch­annel_page

[time00001]

Back EMF is the true power

check out my stuff

Look up time00001 on youtube

I love this stuff

[roguerabbit3]

In my research, I have noticed that some electromagnets seem to work better than others. I set up a spreadsheet to try and figure out the best wire size, coil size, etc..

I found out that the inductance is NOT dependent upon wire size. This was interesting. Currently, I am looking at the L/R ratio as the defining point between under and overunity.

R

[may7charlie]

Hi

Where can I find reed switch which does not get burnt ?

I am making electromagnet which needs to be on/off by fast rotating magnet. Power supply is 12V car battery. Thanks Charlie

[freethisone]

u make over unity if you conserve energy, any peakiness spike is at 90 degrees, so is put back in a cap. do in series, 4 caps 2 charge and 2 discharge. were u see your reed switch, add a low voltage ac flipping circuit 90deree ouy of phase.

hope u have a new idea.

[wewhitt]

So far what Ive seen in literature is that the Back EMF has to be caught in one of the Ethers. In Teslas paper, The dissipation of energy he describes 4 ethers Light, Warmth, Chemical, and Life. Trapping the back EMF / radiant pulse has been most effective in a Chemical (battery). Teslas experiment found Radiant energy is in the ether disrupted in equilibrium using one way, high magnitude pulses of short duration. Thats why little in gets lots more out. Good work man!!!

[waterwart]

where is that?? It wouldn't come through.

[waterwart]

where would a beginner to this technology start looking ?

[m3sca1]

i read in some literature on the adams motor,that when using neo's you need thinner windings and higher voltage to overcome the field strength.

weaker magnets can work with lower volts and thicker windings...