1989 RS dual exhaust w/ x-pipe and moroso spiral mufflers
Loading...
Link to this comment:
Uploader Comments (mw66nova)
All Comments (29)
-
what moroso part number did you install?
-
After destroying the T-5 3 times in my 92 RS I installed the Richmond 6-speed. Just remember when they tell you it's a direct replacement it's total bullshit. Damn good tranny but it's a bit pricey. Stocker weighed @ 75-80 lbs. Richmond weighs in at 125 without the shifter and linkage
-
@WitchhunteR82 I would just buy a T-56 as they are much stronger in stock form than a T-5 which can handle only about 300hp.
-
Got any spare parts?
-
Hi, I have same T-5 transmission but from V6 1988 camaro. Can You tell me which parts i need to install her on 350 L98 engine? I know that i need V8 bellhousing,V8 flywheel but i dont know which clutch? sorry for bad english
-
i fucking want one, how much do these ruN???
-
awsome! what size tires are those?
-
save some iroc's for the rest of us
-
thats a hell of an exhaust, i like it
0:5980 malibu Big blockby drgracer0066,969 views
Featured Video- 4:221990 Camaro 10 second runby mw66nova3,608 views
- 1:49cam only 4.8 gmc runs 13.8 all motorby mw66nova3,025 views
- 0:28Toyota 4runner with sbc 350 X pipe and dual Ins...by jacksonville4x45,224 views
- 0:141986 IROC 383 dual exhaust drive offby mw66nova5,238 views
- 0:55383 Stealth Ram with Ultraflo 4" exhaust idle/revby orr89rocz37,016 views
- 1:41Iroc RS Dual and Single exhaust systemsby mw66nova3,650 views
- 1:48Camaro street car goes 10's on motorby mw66nova2,445 views
- 2:0789 Trans Am 400 Burnout. I rebuilt this car f...by koolkarsusa18,678 views
- 2:40Camaro 10.89 in car camby mw66nova1,956 views
- 7:27How to Install a Cheap Exhaust System and Muffl...by 63lesabre32,859 views
- 1:551986 Camaro True Duals Idle and Revby plasmeh5,204 views
- 1:2674 454 exhaustby jkheslekrants13,825 views
- 1:241989 Camaro RS Burnout 2by feenux8210,672 views
- 0:261989 camaro burnoutby gill922837,270 views
- 0:21my ole 1989 camaro 305 burnout before i sold itby ridelow256,627 views
- 0:2910.89by mw66nova561 views
- 1:1785 camaro with a beast of a engineby quizme4203,519 views
- 0:141989 Camaro Exhaustby Destroyer47905,452 views
- 0:10iroc nitrous 383 true dual 3" exhaust moroso s...by oroc7503,325 views
what did you have to do to the headers to clear the slave cyl? i am wanting to put long tubes on my can
travis1000rr 2 years ago
i cut the collector off and extended it, pointing it slightly down, then just clearanced the extended part with a BFH, worked well...
mw66nova 2 years ago
are you running cats? I got a similar setup and its just too loud without cats, id like to know if your running them or not so i dont feel so bad lol
bvahnee 2 years ago
no cats on this car. the car has not been driven on the road since it was put together because it's not yet complete. we got a ton of stuff to tackle still before we can really do anything. then once we get the interior back together and drive it around, we'll decide if it's going to be too loud. it's much louder than my car with a single 4" w/ a magnaflow muffler and an ls1 though, i can tell you that.
mw66nova 2 years ago
did it have a oxygen censor on it?
nickrd10bk 2 years ago
did what have an oxygen sensor in it? the red car in the video is carbed, so no sensors. my car has a fuel injected ls1, and has an o2 sensor in both collectors. i have put o2 bungs in the collectors of the hedman longtubes before for efi setups.
mw66nova 2 years ago