Chevy 5.3lit Intake R&R HD

This video shows the removal of the intake manifold. I then show cleaning and preperation and torque installation. Thanks for watching and please Like and Comment!

Category:

Autos & Vehicles

Tags:

• 2002
• chevy
• silverado
• 1500
• 5.3lit
• 5.3
• liter
• vortec
• engine
• intake
• auto
• car
• truck
• repair
• do
• it
• yourself
• specfication
• installation
• removal
• srmastertech
• chevrolet
• burnout
• drag
• mustang
• racing
• snapon
• tools

[bink637]

this is one of the best videos (of course, of this type) I have ever seen.Very clear, very concise, very informative. thanks so much

[srmastertech]

@bink637

Thanks for the great comments!

[rkeith8120]

Great video, Going to start my R&R in 11 minutes and 24 seconds. I love the sounds in the back ground. Must be near a drag strip. I swear I heard my Mach1 going down the track.

[srmastertech]

@rkeith8120

Thanks for the comment, and there was a Mach 1 in the mix!

[huskermanaz]

Doing this tomorrow. Thanks a ton, One question, What kind of gaskets did you use? I have the "upgraded" turqoise gaskets but some say to only use perma-dry from felpro? I am replacing the entire intake not just the gaskets.

[srmastertech]

@huskermanaz

I used Perma-dry FelPro gaskets with no flaws! Either gasket will work just as well in my opinion.

[JuliaDevan]

Great job on this video!!! Very informative.

[ROTCbrony]

@machster69 Vortecs have a dry intake manifold, so that's not your problem. Sounds to me like a head gasket or (God forbid) a cracked block. In either case, that's something I would leave to the pros. Best of luck to ya though.

[srmastertech]

@TheChevyguy2002

Both engine are basically the exactly the same, so the procedure should very close. Some vacuum lines may differ from the video though.

[TheChevyguy2002]

i own a 2002 chevy 2500hd with a 6.0L. my knock sensors need to be changed and i am just wondering if the 5.3 intake is the same as the 6.0's?