Small shop saves money with homemade jigs, Part I
Loading...
Top Comments
All Comments (8)
-
Two set ups on the spindle moulder with a front and backstop on the fence would be about 10 times faster.
-
krob63 says he has to move the router table fence. I use spacers against the fence and simply remove the spacers as I need to move the router across the board. If I'm doing five small flutes 3"4 c-c apart, I set the fence to rout the flute in the center, then put two 3/4" spacers clamped to the fence. Run flutes 1 and 5. Remove 1 spacer, run flutes 2 and 4. Remove the other spacer, rout flute 3. All I need is stop blocks. Done in half the time (or less) of this procedure.
-
Be faster on a router table
2 years ago 2
-
Guys))))So much afforts and almost Zero result?
-
I was making some fluted columns yesterday using a router table by constantly adjusting the fence. It was a pain in the butt. I like your jig. It would have saved me a lot of time.
-
Replace a Cnc Router? You must have a really shitty CNC table if you think this is a faster way
- 3:05
shop made jigsby jdn6863142,081 views
- 2:32
Worker killed when saw kicks backby WorkSafeBC38,350 views
- 4:02
homemade scriberby jdn686317,127 views
- 1:52
router table tricksby jdn6863277,878 views
- 2:53
Small shop saves money with homemade jigs, Part IIby CabinetMakerFDM11,864 views
- 1:11
Shaping Parts Using a Template Sled.mp4by handi4548,703 views
- 3:00
my mortise jig in action part 1by jdn6863161,141 views
- 5:26
Wood shop designby Bopbeepbd34,071 views
- 2:50
Tour Our Shopby cbctweb20,098 views
- 2:16
Homemade Coil Winding Jigby Truthbeeknown188,323 views
- 3:51
cheap sharpening methodby jdn686370,558 views
- 1:08
My woodwork 2 - dovetail and finger joints boxes (up to 2011)by AmateurWoodworker33,189 views
- 5:08
DIY 4 Panel wooden Door, part 4. raised panel cutting with a straight routerby agbagb123336,567 views
- 1:54
Introducing The Bowclampby cfeuerzeig32,455 views
- 1:13
Planing Mahogany Body Blankby GuitarBrew19,923 views
- 2:27
Woodhaven Box Joint Jig HDby WoodhavenInc12,718 views
- 8:39
Router tableby tehdoor68,510 views
- 2:21
Homemade router tableby thewoodlover113,538 views
- 1:03
Neck Radius Router Jigby Vandebilt12,598 views
If this is faster, how were you doing it before? Cutting grooves on the saw, manual setups on the jig, screwing the board down. Not to mention it is a large jig and the router has to be mounted everytime.
Why not simply use a router table?
manytoolsmike 1 year ago 9
Seems like you do way too many steps to setup for just one pass through with router. How is this jig helping you? A jig is suppose to help you simplify your work not add to it. Lame video and lame process.
koolhandvuk 1 year ago 4