Cipa Universal Strap-On Towing Mirror - etrailer.com

http://www.etrailer.com/tv-demo_cipa_strap_towing_mirror_40375.aspx

Videos are provided as a guide only. Refer to manufacturer
installation instructions and specs for complete information.
This easily installed universal towing mirror will mount to any mirror with its conforming rubber knobs and securing clamps this mirror will attach easily to any mirror you have on your vehicle. The total length of the mirror is 18 inches and the mirror itself is 5x5-3/4 inches. Before we can install this mirror there's a little prep to be done. First make sure the mirror on your vehicle is nice and clean you don't want to trap any dust or dirt between the pads and the mirror and ruin the finish on your vehicle. First we need to install these pads, with some self adhesive. While we're on the subject with these knobs, we'll show you how adjustable they are. The knobs spin up and down so you can raise the height of them. This knob will spin back down to lock it into place. This will way it will help conform to the curvature of the mirror.

Also these are clamps right here that will clamp onto the mirror itself. The edge will go here and push this flap down and it will secure it in place. Let's go ahead and install this on our vehicle. We'll do a couple test fits by pushing it against your mirror to see if you need to adjust these feet or not. It looks like we're just going to leave it all the way down and go from there. Next we'll show you how to loosen up the straps. First you need to pull the knob straight out, then you can pull them out and get your slack. Next we can take these clips and install them on the mirror. We'll push them down a bit and pull them in. We'll do the same to the bottom. Once you have them clipped in make sure you center it the way you want it and push your knob back in. Now we can tighten the knob up. You might want to wiggle it every now and then just to make sure you take up some slack too. Give it a few tugs to make sure, re-inspect your feet and this one actually looks like it pulled away. Now you need to undo it and redo the feet because you want all of these connecting to the mirror. Spin that out and there you have it and it's really not going to go anywhere. Also you notice there are a couple of extra hooks and pads that came with it. These are in case you mess up or lose one and the hooks are for different style mirrors which helps out for different vehicles. Another nice note about this is it has an air vent on the side which helps cut down on wind resistance and probably less wind vibration too. There you have it for part # 40375 from Cipa, the universal strap on towing mirror.

Category:

Autos & Vehicles

Tags:

• towing
• mirror
• installation
• install
• demonstration
• review
• cipa
• etrailer.com