03 GT Tork Tech Terminator final dyno pull

The final of 3 dyno pulls. Top end of the tune was almost spot on in the first pull, but bottom end needed more timing and fuel pump hit 100% duty cycle at 4500 RPM. 393hp/393tq @10lbs. Second pull showed 405/404@10lbs with the top end of the tune unaltered from the first pull, but the BAP gave the engine the fuel to run full timing. For this pull all we did was swap the factory paper air filter for a K&N drop in, and made 412/408@11lbs.
Car has the TT Terminator kit with a Stiegemeier stage 4 ported Eaton (had to choke it with the factory intake to keep it from making too much boost), 7 inch lower pulley, 3.1 inch billetflow upper pulley, SVT focus pump with BAP, 39 lb injectors, BBK longtubes, weld in Flowmasters, and 4.10 gears. Built by Extreme Performance tuning, Goodyear, AZ.
MMR 600 motor to come.
Dyno sheet:
http://img.photobucket.com/albums/v504/Aurelion/blowndyno11psi.jpg

Category:

Autos & Vehicles

Tags:

• ford
• mustang
• gt
• tork
• tech
• terminator
• cobra
• eaton
• m112
• supercharger