Tacho from Skoda SuperB on VW Passat 3BG

This is a tacho from Skoda running on a VW Passat 3BG. Obviously, I had to swap all the leds from green to blue, and I had to use the needles and the numbers (the papers) from an old VW tacho.

The FIS display it is a lot of work to replace the leds from orange to red... but I wanted to give it a try. I will keep the yellow leds of the FIS for some time and then decide.

The purpose of the swap of the tacho from VW FIS to Skoda FIS is because Skoda has the lamp failure detection functionality that VW does not have

Category:

Autos & Vehicles

Tags:

• lamp
• failure
• vw
• skoda
• passat
• superb
• tacho
• FIS

[Green16v]

Engine sound like tractor :D

[madelgad]

The driver's door was open... anyway I love the tractor sound, specially when I listen to it at the gas station, when I refuel after 1000 km with 55 liters

[madelgad]

The only thing that I had to do is to run a wire from the low beams pin from the tacho (blue connector) to the tempomat switch... superb does not have a light for tempomat, so as I replaced the surface of the tacho with another from a VW tacho, I got back the tempomat light... Maybe there is a possible modification inside the tacho to get the tempomat light on when the switch is on... but at the moment I just made it simpler

[madelgad]

It all works perfectly :D

[glavaR26]

this is not a Superb tacho. Only the board computer display.

[tonyosijek]

how did you make the warning for a broken light

[tonyosijek]

how did you make the warning for a broken light.

[alkarre]

como siempre un monstruo m.delgado

saludos

[mrgreek2002]

Meh, I don't need the light burnt out warning.

[Lanselot1978]

Nice job!

Evry think is work on it?