CNC Ring Coiler/Continuous Kine-Coiler Four Slide 5519

Sleeper/Kinefac Kine-Coiler
Model #915
CNC Ring Coiler/Continuous Coiler
Very Few Hours!
$90,000 for Complete Machine including Payoff Reel
$85,000 for Just the Machine
$7,000 for Just the Payoff Reel.
WIRE GAUGE:
Wire diameter .005 inches to .018 inches with index to 3.
WIRE MATERIAL:
Capable of making springs in stainless steel, music wire, phosphor bronze, beryllium copper, platinum alloys, etc.
Shaped wire with a cross sectional area up to that of .018 inch diameter round wire.
COIL CHARACTERISTICS:
Maximum compression spring OD of .375 inches.
Compression springs with closed ends, closed ends and center, taper, barrel, closed ends with cones.
Continuous closed, open or variable pitch coils of an unlimited length.
Coiler available in either left hand or right hand versions.
FEED ROLLS:
Feed rolls 1.200 inch diameter.
Both feed rolls driven.
Upper feed roll smooth.
Lower feed roll with multiple grooves covering the full wire range .005 inches to .018 inches.
Lower feed roll axially adjustable by # 3-56 adjustment screw for wire size alignment.
Upper feed roll axially adjustable for wear compensation.
Upper feed roll pressure precisely adjustable by calibrated spring unit.
Upper feed roll assembly swings out of the way for visibility of wire line alignment.
Upper and lower feed rolls of carbide.
Lower feed roll direct servo driven.
Minimum wire feed increment .0003 inch.
Maximum wire feed rate 3000 inches per minute.
DIAMETER AXIS:
Coiling point tool holder directly driven by servo mounted actuation cam.
Coiling point CNC radially positionable in .00004 inch increments.
Coiling point laterally positionable by differential translator in .000003 inch increments.
Coiling point vertically adjustable by micrometer in .0005 inch increments.
Coiling point actuation axis can be rotated +30 degrees to -35 degrees with respect to the wire line for two point coiling or other special coiling applications.
Diameter slide has anti-friction linear bearings.
Diameter slide is spring loaded against cam surface.
Diameter slide travel .200 inch.

Coiling point clamp is "V" type to allow use of either preset, square shank coiling points or round shank coiling points.

Category:

Science & Technology

Tags:

• machines