Install TV above fireplace pt 7- install cables

So Cal Home Theater in San Diego. Visit our Do-It-Yourself guide at
http://sdinstall.com/DIY2.html

Category:

Howto & Style

Tags:

• install
• wires
• wire
• cable
• cabling
• TV
• above fireplace
• HDMI
• electric
• electrical
• outlet
• power
• run
• mount
• how to
• do it yourself

[blackandy1000]

Can you tell me if any HDMI cable can be mounted inside the wall? I noticed that some cables actually say "for in wall mount". Just wondering if there was much of a difference.

[acstylin1]

@blackandy1000 You need to use a cable that is UL listed for in-wall use.

[parsineo]

Drilling the edge of the stud out like that is against building code in most jurisdictions as it's considered to compromise it's integrity if it's a load bearing wall. Amateur hour is over. If you want to pass large headed cables such as hdmi, drill two or three consecutive, slightly overlapping 1/2 inch holes with a paddle bit thru the center of the stud and pass the head. This keeps the wire thru the center of the stud, where it belongs per code.

[acstylin1]

@parsineo I'm glad you took the time to watch the videos.  Being that you're a "pro" I would be curious to know why you're looking at instructional videos in the first place, but that's besides the point. I assume that you're a contractor and as a contractor, you should know that this is the standard way of installing cabling, piping, etc for all trades in tough spots. ALL trades use this technique when needed and pass inspection with no problem whatsoever.

[npj66]

@acstylin1 What state passes that work? I have been in the business for 26 years and would never recommend notching studs. I advise all who watch to hire a pro with the tools

to properly run the wiring and install the fixtures. If you own your own home and you have a fire homeowners insurance will find out after the investigators determine the root cause of the fire.

[acstylin1]

@npj66 I'm glad you took the time to watch the videos and thanks for commenting. I don't see how notching a stud and keeping the wires several feet from anything hot around the fireplace became a fire hazard. Sounds like you're making a strong statement to try to make the installation look bad. That's the freedom of the internet I guess. This installation will pass code. No question about it.

[rawgadgets]

@parsineo

Man what are they doing. My install does not have

a hole like that, and I paddle aross, then snag from

below with rods. WOW!

[parsineo]

And nail plates also make it more difficult to make that drywall patch sit level when go to repair it. Not trying to bag on you, but there are better ways than this that meet code for structure and the NEC.

[qixote]

I don't understand why people do this. Sure, in theory it sounds like a good space-saving idea. In reality, it looks tacky and it is not pleasant nor comfortable to constantly look up to watch TV. And if the fireplace is functional, it is a distraction to watching TV. People think they may be impressing others, but I don't think it is impressive at all. No way I would do this with my fireplace.

[NCWC916]

also what I found to work well while pulling your HDMI is when you insert your rods/ fish tape and theres insulation, twirl your rods in a wide circular motion so as to create sort of a groove for the cables to pass with the least amount of resistance from that damn insulation! That technique or sometimes just bend the rods outward away from the wall so as to push the insulation away....also works for making a channel to pas your cables : )