BMS Tour 11 PbPro Master Test

Video showing BMS Master Board V2 running PbPro plain Pic16F886 chip software, polling a PbPro Serial Slave with the Slave Command feature.

The Commands availabe are.

Command 01 = Send Cell Voltage on Master Bus
Command 02 = Turn Off Slave Load




Command 03 = Turn On Slave Loads as Required
Command 04 = Increase Load CutIn Voltage by 10mv
Command 05 = Decrease Load CutIn Voltage by 10mv
Command 06 = Increase Load CutOut Voltage by 10mv
Command 07 = Decrease Load CutOut Voltage by 10mv
Command 08 = Set Slave Load CutIn/CutOut Voltage Defaults
Command 09 = Turn On Slave Load for 0.5 seconds (Flashes Led)
Command 10 = Set Baud rate to 9600bps * Note not supported in Pbpro Master (Fixed at 9600 baud)
Command 11 = Set Baud rate to 2400bps * Note not supported in Pbpro Master
Command 12 = Report Slave Software Version Number

Sorry about the lower quality video this time.

Category:

Autos & Vehicles

Tags:

• lithium
• lifepo4
• phev
• bms
• electric
• vehicle
• ev
• battery
• management
• system
• honda
• insight