How-To Install A Bottom Bracket With Jim Bauer Ride BMX.mp4

i dont own this or take any responsibility for this video just trying to help out others who need it, spreading the word ! This video is orginally from Ridebmx.com and the man in the video is Called jim Bauer, main guy behind Odyssey bmx. hes a genious of design and im just trying to share his helpful tips. owned by RIDEBMX.COM

Category:

Sports

Tags:

• jim
• bauer
• odyssey
• bmx
• bottom
• bracket
• mid
• bb
• aaron
• ross

[vitalownage]

reply ASAP! you know the tube spacer thing in the middle of your bottom bracket? do you REAALLY need it?

[21callum21]

@vitalownage it is not NEEDED, but advised

[PyroJosh222]

i have a question: are 22mm cranks stronger than 19mm cranks? just wondering

[21callum21]

@PyroJosh222 i dont think there is a difference mate

[jonbauer79]

i always had a problem with doing this. i dont care if this isnt your video im just glad i saw it!

[21callum21]

@jonbauer79 good to hear bro!

[INTHISGUYSAID]

no how do you get it out is my ? lol

[21callum21]

@HolyGfunnies shut the fuck up seriously, its not me in the video to start with you tard and why be so god damn picky? its there to help you, obviously YOU KNOW to grease both bearings so why say it

[Iride4FitBike]

how did you guys make that bottom bracket tool?

[stinkmarlin23]

so if i change from 1piece cranks to 3 piece cranks can i just switch the cranks or do i have to change the bottom bracket also?? and do i need to change the freewheel also

[kenneth1234567889]

i need to get new cranks but i dont know what size spindle will fit.....any tips on finding the diameter of the bearing someone please reply!!!!

[MrPorkinsneedsbacon6]

i need that fucking tool i broke 2 pairs of bb just hammering it in

[butchimiller]

@ConnorSexauerFilms yeah thats what i meant. should i just use the one long one? or should i use a couple small ones also just so it will move less?

[ConnorSexauerFilms]

@butchimiller ohh i now know what you mean okay its alright if the spacer between the two bearings if you mean the long one in the middle move. cause once you have your spindle in there it wont move.

[butchimiller]

@ConnorSexauerFilms so should it be tight between the two bearings so it doesnt move back and forth at all? the only problem i see with that is not being able to get it out after its in...

[ConnorSexauerFilms]

@butchimiller It should not be moving if you need to add a spacer and see if that helps and tighten it down as tight as you can

[butchimiller]

should the middle spacer move back and forth inbetween the two bearings? or should it be snug inbetween the two bearings? if its supposed to move back and forth how much should it move back and forth? if i only use the one middle spacer it would move back and forth a lot so im wondering if i should add smaller spacers to the inside so it move back and forth less. thanks for the help