Truly first flight of Align T-Rex 700 Nitro converted to gasoline engine whit Helicommand 3D.
This was the first try to setup the autopilot and I almost crash the helicopter the first time that turned on in 'Position Mode", I will need to conect the Helicommand to the computer through serial cable and do some adjust, then I will post a new video with the result.
hello krumrick2
i have the same configuration of that heli, but i have some problems with rudder, i'm using aurora 9, i have 15% gryo gain but still moving,
can you give me some instructions please?
ps: i use the align 780 gyro.
amiraldz1970 1 month ago
@amiraldz1970
Hi, look...I do not recommend the Helicommand integrated gyro, is not good to secure the tail in the gasser 700's ( not even in electric one).
The best gyro I ever tested to this gassers are the Futaba 611with 9256 tail servo, pretty old but really nice gyro.
A few days ago I installed one of this in another Electric 700's with Helicommand Rigid, same problems as yours, the tail is not firm enough.
krumrick2 1 month ago
@krumrick2
thank you for the answer,
I misspoke, my English a little bad
I wanted to know what the gyro is better for TREX700 gasser, because 780 of ALIGN, I do not like much.
amiraldz1970 1 month ago
@amiraldz1970
Don't worry...my english is not good to rsrsr.
Now...gasser helicopters have serious problems in tail control ( lot of wag), the best gyros for me are Futaba 611 with Futaba 9256 tail Servo.
krumrick2 1 month ago
lovely heli, want to convert my 700n to gasser but dunno where to start!
mark675 1 month ago
@mark675
Hi, take a look at Century Heli USA, they have a really nice conversion for the 700's.
If you need any other info and tips send a personal message with your e-mail.
Regards,
Manuel.
krumrick2 1 month ago