Ford Fusion Magnaflow Exhaust

MagnaFlow 16684 Stainless Steel 2.25"
2009 Ford Fusion SE with SAP
5 speed manual (no 4.5k rpm limiter).... just stock 7kr pm rev limit

Camera doesnt do the exhaust justice it sounds great. very deep and rich tone. doesnt sound ricer/raspy at all.

after 2.5k or higher shifts. its typical to hear a little pop or crackle from unburn fuel (which sounds awesome)

overall, very good exhaust which was louder than expected (a plus in my book)

Category:

Autos & Vehicles

Tags:

• ford fusion
• magnaflow
• exhaust
• steeda
• awr racing
• MT
• SAP
• 1.02 lateral g
• mazda 6i
• mattyo620

[irishhotti2]

$442 from steeda... and yes i do have the CAI (along with some suspension stuff..... like awr racing  endlinks/ steeda swaybars... braces) I felt more torque/ earlier torque after putting on the CAI.

Current 0-60 is 7.8 seconds

*with 180lb passenger, LM-22 blizzak snow tires, ~34 degrees F

(Via MSD dashhawk)

[northsiderollers]

Sweeet exaust!

[irishhotti2]

@northsiderollers thanks for the comment^

[MyMilan1965]

@HollywoodCGD Pretty sure its a 4cyl. Good sound but 4, not V6

[Mustangmatt06]

i want this car and if i got it i would change the exaust

[ThaBR33D]

Ive got the same car.. did you need to do anything special after installing the exhaust? I'm used to motorcycles, and after an exhaust install you usually jet the carbs.

[crimsoninred]

@irishhotti2 how was your mileage? did it boost up or stayed the same?

[HollywoodCGD]

is this the I4 or the V6?

[6fordfusion]

great video, do you have a cold air intake as well? did u feel any difference from the exhaust?

[pauloredivo]

how much was it? and were can i found it thanks