Air bumping an IC

Here we re-heat a board to adjust the IC. Be careful, you can only do this once or twice before the PCB starts to give out. Towards the end of the movie you can see where the air flow actually causes the IC to raise up a bit and center itself. It's common with novices and too high of air flow to blow the chip completely off the board.

Category:

Howto & Style

Tags:

• hot
• air
• rework
• SMD
• soldering
• hotair

[lesleyhenriquez]

@ADABUD659 Reflowing solder.

[lovely232]

@ADABUD659 be a moron, wow xd - you try to reposition a smd

[Smokie181]

@ADABUD659 yeah he didnt want to remove it. Its like resoldering almost. look at 0:32 - 0:33. You can see the chip re-position itself correctly.

[ADABUD659]

WTF was that about, all you did was move it slighty WOW XD

[jumbo621017]

sea mas explicito si no no suba este tipo de informacion que no sirve de nada

[1serge6969]

thats the easy part put the new part lol

[Jebovsek]

first :D