Case mod : window install (thanks to MonsterMawd tutorials)

I cut out the window for my window mod today. I had to go over to a friends house and use his dremel. The bottome cut will be a tight squeex but I can get tape and the uchannel in there to keep the window on.

I have most of the supplies for my next mod. I have the plexiglass, uchannel, fan filter, clear 120mm fan, paint, primer and clear coat.

Category:

Entertainment

Tags:

• case
• mod
• custompc
• modding
• pc
• mods
• dremel
• uchannel
• fan
• window
• cooler
• master
• elite
• 341
• mini
• tower
• plexiglass
• jigsaw
• Media
• PC
• Monstermawd

[baller908790]

how much did the plexi cost

[honitsten]

around $3. not very much. I bought a small one. I only cut off an inch from one end to make it fit where it is.

[baller908790]

where did you get the window from

[honitsten]

I picked up the plexi from Home Depot.

[wheelnut53]

I did pretty good on my first try also I just wish I knew about using a jig saw to cut the bulk of metal.

[honitsten]

I had to pound it straight after. I was leaning on the panel and bent it while cutting. My first time too! LOL.

[ClipCollector]

Came out nice... I wish I had known DIY Home stores had plexi before I bought mine... do they sell U channel too?

[cyber8000]

@honitsten Do you know how I can make a hole for a 360mm fan?

[ThePCtuning1]

gorzej nie mogles spierdolic jedynie mozna jeszcze na torach polozyc i czekac

[shyboy2cute]

classic newegg lol

[0611930024838]

newegg lol

[cleldimar157]

nob.