Dnepr MT10-32 project MegasquirtAVR (Genboard v2.2)
Loading...
45,815
Loading...
Uploader Comments (lenrockk)
see all
All Comments (23)
-
Cool I'm in the prosess of instaling a Megasquirt on my Dnep'r now. Do you share your configuration files? Could possible save me some time
-
Возможно ли купить готовый блок управления? Если да, то где? Боюсь, у меня не получится самостоятельно спаять его, а главное - правильно прошить.
-
Спасибо! Уже нашел.
-
Nádherná hudba ;-)
-
ахуеть)
-
sounds like music to me :D
-
what kind of sensor did you use, an what kind of injectors? Thumb up for the passion added, i love dnepr !
-
респект автору нето что я леворукий...))) еще раз респект
Loading...
Well done, man!
There are several issues as I want to, at its Urals is muddy:
1. Crankshaft position shot with a standard plug, I understand you correctly?
2. What is a control unit used to install the injector and, if configured, how? Firmware?
3. What sensors are connected, where they installed? In general, they used? Valve, air flow sensor, put the valve, idle and lambda sensor?
If possible, laid more information.
113angel113 1 year ago
@113angel113
зайди на оппозит.ру впрыск на вемсе, там подробности
lenrockk 1 year ago
тут просто впрыск топлива и электронное зажигание в одном ; )
lenrockk 2 years ago
how much did this conversion cost ? how much was the ECU ?
Metallbiker 3 years ago
ecu 100$ and the rest 400$ + a lot of time ; )
lenrockk 3 years ago