AKFCG

How to install a semi auto fire control group in an AK.

Category:

Howto & Style

Tags:

• AK
• FCG
• Fire
• Control
• Group

[rtljmc]

is this full auto?

[BuildyourownAK]

@rtljmc no

[rtljmc]

@BuildyourownAK thanks. i dont se the diffence. if i held the trigger down what stops it from cycling?

[BuildyourownAK]

@rtljmc The disconnector, the piece on the back. Simply filing that off doesn't make the gun full auto, as the hammer would ride home with the carrier. A full auto FCG has a safety/auto sear that holds the hammer until the carrier goes into battery. The carrier trips that sear which is what fires the hammer. The Full Auto FCG has more components than the one I'm installing in this video and requires exact receiver modifications to install properly. Don't even think about it, it's a felony.

[akshooter762]

why did you say remove the tapco disconnector spring and put the one in the kit in? are they better or something?

[BuildyourownAK]

@akshooter762 The Tapco FCG's don't come with a spring.

[remingtonguy870]

what kind of ak is that?

[noob5000000]

I never knew about the 'mouse trap' before. That makes it much easier, haha. 

[deadsy209]

Hope you didn't have to find out the hard way about the mouse trap!! Ouch!

Hey do you have any videos about heat treating the receiver?

Thanks!

[semiautoriflelover]

why not put a twist tie on the top so it doesn't snap your hand and pop off hammer?

[numba1stunna4269]

Cool!