Printing a RepRap Mendel frame piece on the Makerbot Cupcake
Loading...
Loading...
2:30
MakerBot Cupcake Decorating Frostruder MK1by makerbot10,085 views- 0:49
Reprap Mendel. My first 3D printby evon101014,813 views
- 1:06
First Assembled Pieces of my Mendel RepRapby jlkeegan2,870 views
- 0:51
RepRap Solder Extruderby rhysjones542,627 views
- 0:46
Reprap Mendel LaserCut - Cartesian Bot Testby plasmator11,828 views
- 1:19
RepRap Mendel making Mendelsby RepRapChannel37,771 views
- 0:34
First Successful Piece of My Mendel RepRap!by jlkeegan7,164 views
- 1:28
Printed Mendel RepRap Parts - 1st Weekendby jlkeegan13,501 views
- 1:06
RepRap Mendel's first printby RepRapChannel10,864 views
- 2:57
MakerBot Cupcake printing the 1st draft of my Droid desk cradleby mrmatz4081,151 views
- 1:08
RepRap@HoGent: Video update on printing a Mendelby BatistLeman2,042 views
- 0:39
RepRap Geared Extruderby RepRapChannel3,978 views
- 1:45
Introduction to Mendel (RepRap v2)by RepRapChannel37,030 views
- 0:25
Printing X Lower for Mendel on MakerBot w/ PLAby ultimachine1,430 views
- 4:27
RepRap Mendel Wiringby RepRapChannel3,381 views
- 0:37
Reprap belt/pulley y axis demoby tmat256883 views
- 3:14
MakerBot Cupcake printing a toilet seat plugby mrmatz408919 views
- 0:46
Tonokip Mendel no pausingby tonokip1,080 views
- 2:30
Aluminium Reprap: first print.by thelastnameavailable9,777 views
- 3:49
RepRap Mendel "Willow" printing in blue PLAby NicholasCLewisGmail5,902 views
Yes, I have read many posts about the cooling issue. I usually start the part with a heat gun pointed in the general direction of the part, but I don't keep it there because my arm gets tired. We'll see how the MakerGear heated platform works when it's released! For now, I will print a heat gun tripod holder to keep the workspace warm. :)
mrmatz408 2 years ago
Most people who have tried to print the larger pieces for Mendel have had problems with the raft lifting and layer separation. It's due to the lower layers cooling down as the print progresses, you should check out some of the cool solutions people are coming up with to get around it.
havocgeneral 2 years ago
@RepRapLogPhase Thanks! Too bad in the end, the part failed. It got 1/2 of the way through when I realized that the lower right corner of the raft had lifted early on, and the corner of the part was curved upward. But the partial part still looks cool! I'm going to try again once I fix my build platform.
mrmatz408 2 years ago
Congratulations!
RepRapLogPhase 2 years ago