Hydrogen Production TEST 001
Uploader Comments (Scarletoccer)
All Comments (14)
-
The immersed clamps should show corrosion after a while. But tell us please if the stainless steel showed some damage. Thanks
-
A good way to look at it is overall power. One of the most simple formulas forelectricity is Power in watts=volts*current. Therefore, you are pulling 288 watts. Considering the relatively little output this is using a lot of energy. Although the output may look impressive, you need to centralize the output to determine the amount of liters per minute.
You also need to run it longer and you'll see the water turn green because of the sodium chloride.
-
hmm...first u add water..add some electrolyte...then put in some electrodes hooked up to a battery and switch it on....voila! and u got electrolysis going.. producing hydrogen..u get less out then the energy u put in...(this isn't how Meyer explained it).
-
Yes the more you use the more you get. I built a electrolyzer and with a pinch of lye you get alot but when I put a teaspoon of lye in it, it did like this guy's did. So the more you put in the more you get as I said earlier. He probably used lye because it works the best, He did say he used something but wasn't going to say what it was.
-
nothing special, the more electrolytes yourve added, which you dont mention is causing the conductivity between the two poles
Hi Leslie
The grade of the stainless dictates the corrosion level, if the correct grades are used and then "burned in" with the right chemicals no further corrosion occurs. As long as true resonance is achieved that is.
PS: Love your red devil costume!
To Dinwald, there is no change to the water if resosnance is achieved, what you see is NOT complete resonance but was just the start of development!!!!
Scarletoccer 3 years ago
no offence...but everyone doing these experiments on youtube seems to do ordinary electolysis....didn't Meyer's cell split water mostly by voltage and not so much with current...sorry just tired of watching regular electrolysis
pascal26in 4 years ago
Again this is not ordinary electrolysis, try to replicate this output yourself and you will get almost nothing!
The unit outputs Pulsed DC and the tubes are a VERY specific length and configuration.
YES more voltage means less current but for a simple test I used what I had on hand.
Scarletoccer 4 years ago
Hello there
The first test uses no additives, the 2nd one uses Iodised salt to etch the pipes.
Regards
Scarletoccer 4 years ago
This is NOT standard electrolysis!
The Device outputs pulsed DC and the length/dimensions of the tubes is critical!
Scarlet
Scarletoccer 4 years ago