How to lube your clutch cable part 1 NEW

I actually do it this time. So no complaints!

Be careful while test riding it. The grab point might be way off.

Category:

Autos & Vehicles

Tags:

• Honda
• 919
• Motorcycle
• Hornet
• 900
• lube
• clutch
• cable

[roynexus6]

Is this a hornet ? What year is your bike ?

[SuperSneakySteve]

@roynexus6 2006

[126Cyclops]

There is a much easier way to do this. Turn the handlebar leaver adjustment all the way IN, and align the adjuster slot with the slot in the leaver housing, then pull the leaver with one hand while applying a slight pulling force on the cable... quickly release the leaver and volia the cable is loose, then just move the cable out 90 degrees in front of the leaver and housing and drop the cable barrel out from the handle.

[rsx123]

Say as much as possible again!

[Cride5]

The other easy way to release the cable. Take off the leaver by undoing the single screw holding it on. Saves fiddling with your clutch adjustment ;-)

[getbiggergeeks]

I followed these instructions. Gradually sprayed in an whole can of molybdenum disulphide grease - I was trying to keep going until I saw grease come out of the far end of the cable! But it never did. When I rode the bike it needed very little force to actuate the clutch, and the grab point is now much less vague. A big improvement, even if I'm not quite finished.

[250Trojan]

Gorgoeus bike! Love the colour. Typical deep Honda red!

[BurningTirez]

string>?

[5erTurbo]

wow, it's like rocket science

[willdabeast21]

Yup, did it this way and the cable came right out